Difficulty
Difficult
Steps
11
Time Required
20 - 30 minutes
Sections
4
- Watch Strap
- 2 steps
- Back Plate
- 1 step
- Battery
- 3 steps
- LED Screen
- 5 steps
Flags
2
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
BackBasis B1 Band
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Watch Strap
- Wedge a plastic opening tool between band contacts.
Wedge a plastic opening tool between band contacts.
1024
Step 2
- Push in plastic opening tool until the components click and pop out of the holder.
- Repeat steps for other band.
Push in plastic opening tool until the components click and pop out of the holder.
Repeat steps for other band.
Step 3
Back Plate
- Remove four 4mm screws using a PH000 screwdriver.
- Remove back plate.
Remove four 4mm screws using a PH000 screwdriver.
Remove back plate.
Step 4
Battery
- Use tweezers to remove elastomeric, or zebra, connector.
Use tweezers to remove elastomeric, or zebra, connector.
Step 5
- Use the flat end of the spudger to carefully lift the battery until adhesive seal is broken.
Use the flat end of the spudger to carefully lift the battery until adhesive seal is broken.
Step 6
- Use the pointy edge of the spudger tool to detach battery leads from the circuit board.
Use the pointy edge of the spudger tool to detach battery leads from the circuit board.
Step 7
LED Screen
- Use PH000 screw driver to remove two 6mm bracketed screws.
- Remove bracket.
Use PH000 screw driver to remove two 6mm bracketed screws.
Remove bracket.
Step 8
- Use PH000 tool to remove two 4mm screws.
Use PH000 tool to remove two 4mm screws.
Step 9
- Desolder the four connecting pins.
Desolder the four connecting pins.
Step 10
- Use spudger tool to lift the clasp of LED connector strip and remove from watch case.
Use spudger tool to lift the clasp of LED connector strip and remove from watch case.
Step 11
- Use spudger tool to remove the LED screen from the watch case.
Use spudger tool to remove the LED screen from the watch case.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Kaitlyn Lee
Member since: 11/06/2017
518 Reputation
4 Guides authored
Badges:
7
+4 more badges
Team
IUPUI, Team S6-G1, Baechle Fall 2017
Member of IUPUI, Team S6-G1, Baechle Fall 2017
IUPUI-BAECHLE-F17S6G1
4 Members
4 Guides authored
