Difficulty
Moderate
Steps
3
Time Required
20 - 35 minutes
Sections
1
- Air and O2 Blender
- 3 steps
Flags
0
BackBear 1000 Ventilator
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Air and O2 Blender
- Remove the ribbon cable at the connection on the oxygen blender control board.
Remove the ribbon cable at the connection on the oxygen blender control board.
1024
Step 2
- Mark the plastic hoses attached to the oxygen blender (so you can put them back on the same way) and then remove.
Mark the plastic hoses attached to the oxygen blender (so you can put them back on the same way) and then remove.
Step 3
- The air/oxygen blender has two screws close to the control board. Remove them and remove the unit.
The air/oxygen blender has two screws close to the control board. Remove them and remove the unit.
To reassemble your device, follow these instructions in reverse order. Perform an OVP test to check proper installment.
NOTE: do not interchange control boards with non-socketed ones!
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
William Burns
Member since: 04/06/2020
285 Reputation
2 Guides authored
Badges:
5
+2 more badges
Team
Cal Poly, Team S7-G12, Paton Fall 2020
Member of Cal Poly, Team S7-G12, Paton Fall 2020
CPSU-PATON-F20S7G12
2 Members
6 Guides authored
