Difficulty
Moderate
Steps
4
Time Required
25 minutes
Sections
1
- Filter
- 4 steps
Flags
0
BackBear 1000 Ventilator
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Filter
- Turn off the ventilator and disconnect from AC power and pressurized gas at the wall sources.
Turn off the ventilator and disconnect from AC power and pressurized gas at the wall sources.
1024
Step 2
- Open the ventilator by removing the console retaining screw.
Open the ventilator by removing the console retaining screw.
Step 3
- Vacuum all surfaces inside the ventilator. Be sure to reach areas around connectors, circuit boards and pneumatic assembies.
Vacuum all surfaces inside the ventilator. Be sure to reach areas around connectors, circuit boards and pneumatic assembies.
Step 4
- Remove old filters in back panel and replace with new ones.
Remove old filters in back panel and replace with new ones.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Eli Ferman
Member since: 04/08/2020
607 Reputation
4 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team S7-G12, Paton Fall 2020
Member of Cal Poly, Team S7-G12, Paton Fall 2020
CPSU-PATON-F20S7G12
2 Members
6 Guides authored
