Difficulty

Moderate

Steps

14

Time Required

                          25 - 35 minutes

Sections

3

  • Air and O2 Blender
  • 3 steps
  • Air and O2 Inlet Manifold
  • 4 steps
  • Power Entry Module
  • 7 steps

Flags

0

  • BackBear 1000 Ventilator

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Air and O2 Blender
  • Remove the ribbon cable at the connection on the oxygen blender control board.

Remove the ribbon cable at the connection on the oxygen blender control board.

1024

Step 2

  • Mark the plastic hoses attached to the oxygen blender (so you can put them back on the same way) and then remove.

Mark the plastic hoses attached to the oxygen blender (so you can put them back on the same way) and then remove.

Step 3

  • The air/oxygen blender has two screws close to the control board. Remove them and remove the unit.

The air/oxygen blender has two screws close to the control board. Remove them and remove the unit.

Step 4

              Air and O2 Inlet Manifold
  • Remove the pneumatic and electrical connections labeled.

Remove the pneumatic and electrical connections labeled.

Step 5

  • Remove the water trap bowls on the rear of the unit.

Remove the water trap bowls on the rear of the unit.

Step 6

  • Remove the four screws and remove the manifold.

Remove the four screws and remove the manifold.

Step 7

  • Remove the two screws holding the power supply to the manifold.

Remove the two screws holding the power supply to the manifold.

Step 8

              Power Entry Module
  • Mark or label the 6 faston connections as to position and remove

Mark or label the 6 faston connections as to position and remove

Step 9

  • Mark or label the two wires going to the power switch and remove at the power switch end

Mark or label the two wires going to the power switch and remove at the power switch end

Step 10

  • Using an allen wrench, remove the power cord retaining bracket.

Using an allen wrench, remove the power cord retaining bracket.

Step 11

  • Using an allen wrench, remove the mounting screwa and nuts from the Power Entry Module.

Using an allen wrench, remove the mounting screwa and nuts from the Power Entry Module.

Step 12

  • After removing the heat shrink tubing, unsolder the two lower wires from the Power Entry Module, noting locations.

After removing the heat shrink tubing, unsolder the two lower wires from the Power Entry Module, noting locations.

Step 13

  • Solder the wires to the replacement module, covering the joints with heat shrink tubing.

Solder the wires to the replacement module, covering the joints with heat shrink tubing.

Step 14

  • Transfer the voltage selector drum from the original module to the replacement and reinstall.

Transfer the voltage selector drum from the original module to the replacement and reinstall.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Eli Ferman

Member since: 04/08/2020

607 Reputation

                                      4 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team S7-G12, Paton Fall 2020                        

                                                  Member of Cal Poly, Team S7-G12, Paton Fall 2020 



                    CPSU-PATON-F20S7G12                     


                                            2 Members                     


                                            6 Guides authored