Difficulty

Moderate

Steps

7

Time Required

                          20 minutes

Sections

2

  • Beboncool Nintendo Switch Gamepad Disassembly
  • 5 steps
  • Battery
  • 2 steps

Flags

0

  • BackBeboncool Gamepad for Nintendo Switch

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Beboncool Nintendo Switch Gamepad Disassembly
  • Use the plastic opening tool to remove the blue plastic grips from the sides of the controller.

Use the plastic opening tool to remove the blue plastic grips from the sides of the controller.

1024

Step 2

  • Use the Phillips #0 screwdriver to remove the seven 5mm screws from the back of the controller.

Use the Phillips #0 screwdriver to remove the seven 5mm screws from the back of the controller.

Step 3

  • Gently separate the two halves of the controller.
  • As the two covers come apart the L1 and R1 button, will fall free from the controller. Be sure not to lose them if they should pop out and fall.
  • Be sure to slide the small circuit boards out of the covers to be able to separate the two halves

Gently separate the two halves of the controller.

As the two covers come apart the L1 and R1 button, will fall free from the controller. Be sure not to lose them if they should pop out and fall.

Be sure to slide the small circuit boards out of the covers to be able to separate the two halves

Step 4

  • Use the Phillips #0 screwdriver to remove the two 3.5mm screws holding the circuit board in place.

Use the Phillips #0 screwdriver to remove the two 3.5mm screws holding the circuit board in place.

Step 5

  • Lift the motherboard from the back case with the vibration motors and button boards attached.

Lift the motherboard from the back case with the vibration motors and button boards attached.

Step 6

              Battery
  • Carefully separate the battery which is adhered to the circuit board.

Carefully separate the battery which is adhered to the circuit board.

Step 7

  • Remove the battery by melting the solder to disconnect the battery leads.
  • For help with soldering best practices, check out this How to Solder and Desolder Components Guide.

Remove the battery by melting the solder to disconnect the battery leads.

For help with soldering best practices, check out this How to Solder and Desolder Components Guide.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Riley McCullough

Member since: 01/30/2020

282 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Embry-Riddle Aeronautical University, Team S17-G9, Lamothe Spring 2020                        

                                                  Member of Embry-Riddle Aeronautical University, Team S17-G9, Lamothe Spring 2020 



                    ERAU-LAMOTHE-S20S17G9                     


                                            4 Members                     


                                            12 Guides authored