Bed Head Wave Artist Deep Waver Lower Handle Housing Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 - 10 minutes

Sections

Lower Handle Housing
6 steps

Flags

BackBed Head Wave Artist Deep Waver
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Lower Handle Housing

Before disassembling your Deep Waver, be sure to unplug the device to avoid electric shock, and make sure the heating elements of the device are cool to avoid burns.
Unlock the handle of your Deep Waver to gain access to the screws you need to remove.
Remove two 10 mm Phillips #01 screws from the lower handle housing.
Remove one 10 mm Phillips #02 screw from the lower handle housing.

Before disassembling your Deep Waver, be sure to unplug the device to avoid electric shock, and make sure the heating elements of the device are cool to avoid burns.

Unlock the handle of your Deep Waver to gain access to the screws you need to remove.

Remove two 10 mm Phillips #01 screws from the lower handle housing.

Remove one 10 mm Phillips #02 screw from the lower handle housing.

1024

Step 2

Pry the black screw cover off the side of the lower handle housing using a fine-point spudger or pick. This side will have the model number and other product information embossed on it.

Pry the black screw cover off the side of the lower handle housing using a fine-point spudger or pick. This side will have the model number and other product information embossed on it.

Step 3

Remove one 10 mm Phillips 1 screw from the handle joint.

Remove one 10 mm Phillips 1 screw from the handle joint.

Step 4

Pry the black screw cover off the other side of the lower handle housing. This side will have the power switch located on it.

Pry the black screw cover off the other side of the lower handle housing. This side will have the power switch located on it.

Step 5

Cut along the length of the black housing retainer with a rotary tool to split and remove the retainer.

Cut along the length of the black housing retainer with a rotary tool to split and remove the retainer.

Step 6

Split the lower handle housing apart using a plastic opening tool.
Begin splitting the housing at one end rather than the center to avoid cracking the casing.

Split the lower handle housing apart using a plastic opening tool.

Begin splitting the housing at one end rather than the center to avoid cracking the casing.

To reassemble your device, follow these instructions in reverse order. Once each half of the housing have been put back together, install a new Housing Retainer to replace the one you cut off.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Grant Peters

Member since: 11/06/2017

401 Reputation

                                      4 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       IUPUI, Team S6-G3, Baechle Fall 2017                        

                                                  Member of IUPUI, Team S6-G3, Baechle Fall 2017 



                    IUPUI-BAECHLE-F17S6G3                     


                                            3 Members                     


                                            4 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team