Difficulty

Moderate

Steps

4

Time Required

                          30 minutes

Sections

1

  • Fuse
  • 4 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackBelkin Car Charger 3.4A Power Adapter Model FBJ187

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Fuse
  • That’s what the Car Charger looks like.

That’s what the Car Charger looks like.

1024

Step 2

  • The two plastic half-shells front are plugged and glued (plastic welded). Using a sharp knife (or similar thin, sturdy object), prick between the negative pole and the plastic housing on both sides and press the two plastic halves apart.

The two plastic half-shells front are plugged and glued (plastic welded). Using a sharp knife (or similar thin, sturdy object), prick between the negative pole and the plastic housing on both sides and press the two plastic halves apart.

Step 3

  • In the first picture on the top right above the red wire is a small white soldered fuse chip. Whether the fuse is OK can be checked with a continuity tester or ohmmeter. The fuse can be soldered and replaced, or more simply a very thin wire can be soldered over the fuse as shown in the picture.

In the first picture on the top right above the red wire is a small white soldered fuse chip. Whether the fuse is OK can be checked with a continuity tester or ohmmeter. The fuse can be soldered and replaced, or more simply a very thin wire can be soldered over the fuse as shown in the picture.

Step 4

  • The two half-shells are not completely identical. When assembling, pay attention to the correct orientation. The small round pins fit into the corresponding holes. Before gluing with seconds glue, check the function in a 12V car socket.

The two half-shells are not completely identical. When assembling, pay attention to the correct orientation. The small round pins fit into the corresponding holes. Before gluing with seconds glue, check the function in a 12V car socket.

Repeat the steps in order to reassemble your device.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             


        Israel is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

Israel

Author

                                      with 1 other contributor 


                    Dhyan

Member since: 06/26/2017

128 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge