Difficulty

Moderate

Steps

9

Time Required

                          8 minutes

Sections

4

  • Case
  • 3 steps
  • Front Casing
  • 1 step
  • Speaker
  • 4 steps
  • Switch Cover
  • 1 step

Flags

0

  • BackBelkin NetCam HD Plus

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Case
  • Use a wrench to loosen up the stand from the back in order to hold the NetCam more comfortably.

Use a wrench to loosen up the stand from the back in order to hold the NetCam more comfortably.

1024

Step 2

  • Work a plastic opening tool into the seam and pry the face plate away from the back panel.

Work a plastic opening tool into the seam and pry the face plate away from the back panel.

Step 3

  • Use pressure to separate the covers.
  • When pulling the device apart, separate from the bottom up in order to avoid pulling the wiring at the top apart.

Use pressure to separate the covers.

When pulling the device apart, separate from the bottom up in order to avoid pulling the wiring at the top apart.

Step 4

              Front Casing
  • Carefully use your fingers to gently pull out the white attachment from the tan colored part.

Carefully use your fingers to gently pull out the white attachment from the tan colored part.

Step 5

              Speaker
  • Use a Phillips #0 screwdriver to take out the two 1.2 mm screws on the board.

Use a Phillips #0 screwdriver to take out the two 1.2 mm screws on the board.

Step 6

  • With your fingers, pull the circuit board out of the back casing.
  • When pulling the board up be sure to do so carefully so you do not break the cord which is attached on the back side.

With your fingers, pull the circuit board out of the back casing.

When pulling the board up be sure to do so carefully so you do not break the cord which is attached on the back side.

Step 7

  • Gently pull the speaker out of the holder from the back of the cover.

Gently pull the speaker out of the holder from the back of the cover.

Step 8

  • The speaker wires are attached with the board. It can be unattached gently by pulling out the white attachment from the port.

The speaker wires are attached with the board. It can be unattached gently by pulling out the white attachment from the port.

Step 9

              Switch Cover
  • On the back of the board pull the switch slowly upward to take it off.

On the back of the board pull the switch slowly upward to take it off.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 5 other contributors 


                    Destinie DiazVerdejo

Member since: 10/04/2016

805 Reputation

                                      7 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       USF Tampa, Team 3-5, Sullivan Fall 2016                        

                                                  Member of USF Tampa, Team 3-5, Sullivan Fall 2016 



                    USFT-SULLIVAN-F16S3G5                     


                                            4 Members                     


                                            14 Guides authored