Difficulty

Moderate

Steps

8

Time Required

                          20 - 25 minutes

Sections

2

  • Lens Assembly
  • 3 steps
  • Internal Screen
  • 5 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackBell and Howell DNV16HDZ

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Lens Assembly
  • Remove the five 30mm Phillips #0 screws on the bottom of the camera.

Remove the five 30mm Phillips #0 screws on the bottom of the camera.

1024

Step 2

  • Use a plastic opening tool to disconnect the internal hinges that snaps the camera into place.
  • Using a plastic opening tool is important since a metal one will scratch or damage the thin plastic hinges that hold the camera together.

Use a plastic opening tool to disconnect the internal hinges that snaps the camera into place.

Using a plastic opening tool is important since a metal one will scratch or damage the thin plastic hinges that hold the camera together.

Step 3

  • It will still be connected by a plastic film. This can also be disconnected by pulling up the white part where it connects to the light circuit board.

It will still be connected by a plastic film. This can also be disconnected by pulling up the white part where it connects to the light circuit board.

Step 4

              Internal Screen
  • Pull the side with the hand strap upwards to disconnect it from the camcorder.

Pull the side with the hand strap upwards to disconnect it from the camcorder.

Step 5

  • Remove the battery.
  • Remove the four 30 mm Phillips #0 screws on the back.

Remove the battery.

Remove the four 30 mm Phillips #0 screws on the back.

Step 6

  • On the hinge of the camcorder remove the two 30 mm Phillips #0 screws.
  • Remove blue piece holding it together.
  • Remove the 50 mm Phillips #0 screw.

On the hinge of the camcorder remove the two 30 mm Phillips #0 screws.

Remove blue piece holding it together.

Remove the 50 mm Phillips #0 screw.

Step 7

  • Use the plastic opening tool and slowly pry open the side.
  • Now pull the part with camcorder out.
  • There is a wire connecting these two pieces using to much force will damage the camcorder.

Use the plastic opening tool and slowly pry open the side.

Now pull the part with camcorder out.

There is a wire connecting these two pieces using to much force will damage the camcorder.

Step 8

  • Have the screen open and twist it 90 degrees unscrew the 40 mm screw.
  • Repeat for the other side.
  • Use the plastic opening tool to pry the outer part of the screen, now attach the new one.

Have the screen open and twist it 90 degrees unscrew the 40 mm screw.

Repeat for the other side.

Use the plastic opening tool to pry the outer part of the screen, now attach the new one.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Jerry Hadjah

Member since: 03/04/2016

525 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       UMass Dartmouth, Team 8-4, Botvin Spring 2016                        

                                                  Member of UMass Dartmouth, Team 8-4, Botvin Spring 2016 



                    UMASSD-BOTVIN-S16S8G4                     


                                            3 Members                     


                                            12 Guides authored