Difficulty

Moderate

Steps

5

Time Required

                          10 - 20 minutes

Sections

2

  • Lens Assembly
  • 3 steps
  • LED
  • 2 steps

Flags

0

  • BackBell and Howell DNV16HDZ

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Lens Assembly
  • Remove the five 30mm Phillips #0 screws on the bottom of the camera.

Remove the five 30mm Phillips #0 screws on the bottom of the camera.

1024

Step 2

  • Use a plastic opening tool to disconnect the internal hinges that snaps the camera into place.
  • Using a plastic opening tool is important since a metal one will scratch or damage the thin plastic hinges that hold the camera together.

Use a plastic opening tool to disconnect the internal hinges that snaps the camera into place.

Using a plastic opening tool is important since a metal one will scratch or damage the thin plastic hinges that hold the camera together.

Step 3

  • It will still be connected by a plastic film. This can also be disconnected by pulling up the white part where it connects to the light circuit board.

It will still be connected by a plastic film. This can also be disconnected by pulling up the white part where it connects to the light circuit board.

Step 4

              LED
  • Take out the two 20 mm Phillips #0 screws that attach it to the shutter.

Take out the two 20 mm Phillips #0 screws that attach it to the shutter.

Step 5

  • The two 30 mm Phillips #0 screws left can be removed to gain access to the circuit board along with the LED.
  • From here we can pop out the LED using the wedge or your fingers if you can manage it.

The two 30 mm Phillips #0 screws left can be removed to gain access to the circuit board along with the LED.

From here we can pop out the LED using the wedge or your fingers if you can manage it.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Donald Desrosier

Member since: 03/11/2016

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       UMass Dartmouth, Team 8-4, Botvin Spring 2016                        

                                                  Member of UMass Dartmouth, Team 8-4, Botvin Spring 2016 



                    UMASSD-BOTVIN-S16S8G4                     


                                            3 Members                     


                                            12 Guides authored