Difficulty

Very easy

Steps

11

Time Required

                          3 - 10 minutes

Sections

1

  • Washers
  • 11 steps

Flags

2

Bullets!

Better coordination with markups and the color/type of bullets will help make this guide more clear!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackKnife

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Close the blade and turn the knife to the side that has the belt clip
  • Be sure to make note of what side the belt clip is on for reassembly.

Be sure to make note of what side the belt clip is on for reassembly.

1024

Step 2

              Remove screws
  • Use a T6 bit to remove the two screws holding the belt clip.

Use a T6 bit to remove the two screws holding the belt clip.

Step 3

              Remove T6 Screws
  • Use the T6 bit to remove the four screws holding the handle in place.

Use the T6 bit to remove the four screws holding the handle in place.

Step 4

              Turn the knife over
  • Turn the knife over and remove one T6 screw.

Turn the knife over and remove one T6 screw.

Step 5

              Remove the T8 screw
  • Turn the knife over and remove the T8 screw that is going through the hinge.

Turn the knife over and remove the T8 screw that is going through the hinge.

Step 6

              Remove the handle
  • Once you’ve removed the screw, you can remove the handle.

Once you’ve removed the screw, you can remove the handle.

Step 7

              Drive pin out of the other handle
  • Using the T6 bit, drive the hinge pin out of the other handle.

Using the T6 bit, drive the hinge pin out of the other handle.

Step 8

              Remove the other handle
  • Once you’ve done this you can remove the other handle.

Once you’ve done this you can remove the other handle.

Step 9

              Slide the blade out of the frame
  • Be sure to keep both brass washers. Sometimes they will stick to the frame or the blade.

Be sure to keep both brass washers. Sometimes they will stick to the frame or the blade.

Step 10

              Sand both sides of copper
  • Using 600 grit sandpaper and a flat surface, rub both sides of the copper washers until there is new material showing.

Using 600 grit sandpaper and a flat surface, rub both sides of the copper washers until there is new material showing.

Step 11

              Reverse process to re assemble
  • Reverse process to re assemble.

Reverse process to re assemble.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Spin Modder

Member since: 07/21/2022

193 Reputation

                                      1 Guide authored                  



                       Badges:
                       1