Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

2

  • Spark Plug Disconnection
  • 1 step
  • Blade
  • 6 steps

Flags

0

  • BackBilly Goat Brush Cutter BC2600HHF (2015)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Spark Plug Disconnection
  • Grab the plastic housing at the end of the spark plug wire.
  • Pull firmly to disconnect the wire from the spark plug.

Grab the plastic housing at the end of the spark plug wire.

Pull firmly to disconnect the wire from the spark plug.

1024

Step 2

              Blade
  • Lift to raise the front end of the brush cutter.
  • Place a jack stand or other secure support under the deck to prevent the brush cutter from tipping forward.

Lift to raise the front end of the brush cutter.

Place a jack stand or other secure support under the deck to prevent the brush cutter from tipping forward.

Step 3

  • Use a 13/16" socket to remove the bolt securing the blade.
  • If needed, wedge a wood block between the blade and the deck to prevent the blade from turning.
  • During reassembly, make sure the blade is fully seated on the spindle, and use a torque wrench to tighten the bolt to 33-38 ft lbs.

Use a 13/16" socket to remove the bolt securing the blade.

If needed, wedge a wood block between the blade and the deck to prevent the blade from turning.

During reassembly, make sure the blade is fully seated on the spindle, and use a torque wrench to tighten the bolt to 33-38 ft lbs.

Step 4

  • Wear gloves or be careful when handling the blade.
  • Remove the bolt and friction washer, and remove the blade.
  • Use a new bolt and washer when replacing the blade.
  • If the large cylindrical blade adapter falls off the spindle, check to make sure the key is correctly positioned inside the adapter, and then align the key with the notch on the spindle when installing it.

Wear gloves or be careful when handling the blade.

Remove the bolt and friction washer, and remove the blade.

Use a new bolt and washer when replacing the blade.

If the large cylindrical blade adapter falls off the spindle, check to make sure the key is correctly positioned inside the adapter, and then align the key with the notch on the spindle when installing it.

Step 5

  • Use a 3/8" socket or wrench to remove the four 21 mm bolts securing the top cover to the deck.

Use a 3/8" socket or wrench to remove the four 21 mm bolts securing the top cover to the deck.

Step 6

  • Lift and remove the top cover.

Lift and remove the top cover.

Step 7

  • Using a 9/16” socket or wrench, make sure the bolt at the top of the spindle is tight.

Using a 9/16” socket or wrench, make sure the bolt at the top of the spindle is tight.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor 


                    Jeff Suovanen

Member since: 08/06/2013

401,023 Reputation

                                      261 Guides authored                  



                       Badges:
                       48







                                                        +45 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,769 Guides authored