Difficulty

Moderate

Steps

6

Time Required

                          4 hours

Sections

3

  • Spark Plug Disconnection
  • 1 step
  • Rear Guard
  • 3 steps
  • Transaxle Drive Belt
  • 2 steps

Flags

0

  • BackBilly Goat Brush Cutter BC2600HHF (2015)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Spark Plug Disconnection
  • Grab the plastic housing at the end of the spark plug wire.
  • Pull firmly to disconnect the wire from the spark plug.

Grab the plastic housing at the end of the spark plug wire.

Pull firmly to disconnect the wire from the spark plug.

1024

Step 2

              Rear Guard
  • Use a 1/2" socket or wrench to remove the two 26 mm bolts securing the rear guard to the back end of the brush cutter.

Use a 1/2" socket or wrench to remove the two 26 mm bolts securing the rear guard to the back end of the brush cutter.

Step 3

  • The brush cutter is heavy—get help before attempting to lift it.
  • If you choose to tip the brush cutter onto its side, first drain the oil and gas.
  • Raise and support the back end of the brush cutter—or tip it carefully onto its side—in order to access the bottom cover.

The brush cutter is heavy—get help before attempting to lift it.

If you choose to tip the brush cutter onto its side, first drain the oil and gas.

Raise and support the back end of the brush cutter—or tip it carefully onto its side—in order to access the bottom cover.

Step 4

  • Use a 3/8” socket or wrench to remove the four 21 mm bolts securing the rear guard.
  • Remove the guard.

Use a 3/8” socket or wrench to remove the four 21 mm bolts securing the rear guard.

Remove the guard.

Step 5

              Transaxle Drive Belt
  • Relieve the tension on the transaxle drive belt by pressing on the back end of the tensioning arm. (Alternatively, use a pry bar on the front end of the tensioning arm, or remove the tensioning spring.)
  • Slip the transaxle drive belt off the drive pulley.

Relieve the tension on the transaxle drive belt by pressing on the back end of the tensioning arm. (Alternatively, use a pry bar on the front end of the tensioning arm, or remove the tensioning spring.)

Slip the transaxle drive belt off the drive pulley.

Step 6

  • Free the belt by sliding it out between the transaxle pulley and the spindle belt.
  • Remove the transaxle drive belt.

Free the belt by sliding it out between the transaxle pulley and the spindle belt.

Remove the transaxle drive belt.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 1 other contributor 


                    Jeff Suovanen

Member since: 08/06/2013

401,023 Reputation

                                      261 Guides authored                  



                       Badges:
                       48







                                                        +45 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,769 Guides authored