Difficulty
Moderate
Steps
7
Time Required
Suggest a time??
Sections
2
- Control Board
- 6 steps
- Transformer
- 1 step
Flags
3
Needs More Images
A few more images would make this guide’s procedures crystal clear.
Better Introduction
Improve this guide by completing or revising its introduction.
Missing Details
Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.
BackBionaire BAP 600
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Control Board
- Unplug 7 pin connector
Unplug 7 pin connector
1024
Step 2
- Unplug 2 pin wires which connects the front LED’s.
Unplug 2 pin wires which connects the front LED’s.
Step 3
- Remove two screws
Remove two screws
Step 4
- Unplug pins
- Use scissors to cut zip ties
Unplug pins
Use scissors to cut zip ties
Step 5
- Unplug rest of pin connections
- Remove Neutral and Hot wires
- They are the two black wires
- Pull them out
Unplug rest of pin connections
Remove Neutral and Hot wires
They are the two black wires
Pull them out
Step 6
- Unscrew two screws
- Inspect capacitor for any bulges ( if it has a bulge , it means it is need to be replaced)
- Check for burnt solder in the back of circuit board
Unscrew two screws
Inspect capacitor for any bulges ( if it has a bulge , it means it is need to be replaced)
Check for burnt solder in the back of circuit board
Step 7
Transformer
- Use screwdriver to remove screws
Use screwdriver to remove screws
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Alexander Tarancon
Member since: 10/12/2016
49 Reputation
2 Guides authored
Badges:
5
+2 more badges
Team
IUPUI, Team 4-4, Baechle Fall 2016
Member of IUPUI, Team 4-4, Baechle Fall 2016
IUPUI-BAECHLE-F16S4G4
5 Members
7 Guides authored
