Difficulty
Moderate
Steps
10
Time Required
15 minutes
Sections
1
- Control Panel
- 10 steps
Flags
0
BackBissell SpotBot Pet
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Control Panel
- Start here.
Start here.
1024
Step 2
- Remove the container on the right side of the vacuum.
Remove the container on the right side of the vacuum.
Step 3
- Lift the tap on top of the vacuum, and then remove the container on the left side of the vacuum.
Lift the tap on top of the vacuum, and then remove the container on the left side of the vacuum.
Step 4
- Remove the left container of the vacuum.
Remove the left container of the vacuum.
Step 5
- Remove the four screws on the top of the device.
Remove the four screws on the top of the device.
Step 6
- Lift the top of the device off once the screws are removed.
Lift the top of the device off once the screws are removed.
Step 7
- Unplug the ribbon cable from the motherboard.
Unplug the ribbon cable from the motherboard.
Step 8
- Separate the top piece and flip it upside down.
Separate the top piece and flip it upside down.
Step 9
- Remove the screws holding the motherboard in place.
Remove the screws holding the motherboard in place.
Step 10
- Remove the motherboard from the top piece. Repair or replace the motherboard if it is faulty.
Remove the motherboard from the top piece. Repair or replace the motherboard if it is faulty.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 2 other contributors
Anthony Bonvino
Member since: 09/26/2017
437 Reputation
2 Guides authored
Badges:
13
+10 more badges
Team
Cal Poly, Team S7-G3, Banghart Fall 2017
Member of Cal Poly, Team S7-G3, Banghart Fall 2017
CPSU-BANGHART-F17S7G3
4 Members
4 Guides authored
Sue Loberger - May 29, 2018
Reply
Where can I buy the part?
