Black And Decker Bdedmt Circuit Board Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 minutes

Sections

Armature
2 steps
Circuit Board
2 steps

Flags

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

BackBlack and Decker BDEDMT
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Detach Matrix Attachment

Remember to disconnect the device from all external power sources.
To detach the matrix attachment piece, press down on the attachment release button located at the top of the device.
Leaving your finger pressed down on the button, simply pull on the attachment to release it.

Remember to disconnect the device from all external power sources.

To detach the matrix attachment piece, press down on the attachment release button located at the top of the device.

Leaving your finger pressed down on the button, simply pull on the attachment to release it.

1024

Step 2

              Remove Mounting Hardware

Using a JIS 1 screwdriver, unscrew seven 19mm outer screws located on the armature.
Using the same screwdriver, unscrew the 12mm outer screw located on the armature.

Using a JIS 1 screwdriver, unscrew seven 19mm outer screws located on the armature.

Using the same screwdriver, unscrew the 12mm outer screw located on the armature.

Step 3

              Circuit Board

There will be a white cord that runs from the power cord base to the circuit board located slightly above.
Use the tweezers to detach the entire white cord and blue connection piece as a whole from the circuit board.

There will be a white cord that runs from the power cord base to the circuit board located slightly above.

Use the tweezers to detach the entire white cord and blue connection piece as a whole from the circuit board.

Step 4

There will be one black wire, a thin white wire and a thin red wire connecting to the trigger module from the circuit board. Using your needle nose tweezers insert one of the ends into the release slot below the white wire.
Make sure to aim the tweezers toward the wire.
Lift the end of the tweezers to release the wire.
The Circuit board is now free.
Do not force the removal of the wire.
Remember to reinsert the wires to their corresponding slots when reassembling.

There will be one black wire, a thin white wire and a thin red wire connecting to the trigger module from the circuit board. Using your needle nose tweezers insert one of the ends into the release slot below the white wire.

Make sure to aim the tweezers toward the wire.

Lift the end of the tweezers to release the wire.

The Circuit board is now free.

Do not force the removal of the wire.

Remember to reinsert the wires to their corresponding slots when reassembling.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Edgardo Gutierrez Jr

Member since: 01/27/2016

329 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       UW Tacoma, Team 1-2, Rose Winter 2016                        

                                                  Member of UW Tacoma, Team 1-2, Rose Winter 2016 



                    UWT-ROSE-W16S1G2                     


                                            4 Members                     


                                            11 Guides authored

Markup Mishap#

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Markup Mishap

Introduction

What you need

Team