Difficulty

Easy

Steps

5

Time Required

                          7 minutes

Sections

2

  • Armature
  • 2 steps
  • Directional Switch
  • 3 steps

Flags

1

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

  • BackBlack and Decker BDEDMT

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Detach Matrix Attachment
  • Remember to disconnect the device from all external power sources.
  • To detach the matrix attachment piece, press down on the attachment release button located at the top of the device.
  • Leaving your finger pressed down on the button, simply pull on the attachment to release it.

Remember to disconnect the device from all external power sources.

To detach the matrix attachment piece, press down on the attachment release button located at the top of the device.

Leaving your finger pressed down on the button, simply pull on the attachment to release it.

1024

Step 2

              Remove Mounting Hardware
  • Using a JIS 1 screwdriver, unscrew seven 19mm outer screws located on the armature.
  • Using the same screwdriver, unscrew the 12mm outer screw located on the armature.

Using a JIS 1 screwdriver, unscrew seven 19mm outer screws located on the armature.

Using the same screwdriver, unscrew the 12mm outer screw located on the armature.

Step 3

              Directional Switch
  • Gently pull up on the trigger module.
  • Be sure to not loosen or disturb any wiring.

Gently pull up on the trigger module.

Be sure to not loosen or disturb any wiring.

Step 4

  • With the trigger module out of the way you will then remove the metal piece that is located behind the directional switch and has the spring attached to it.
  • Do this by simply pulling up on the metal with your fingers or your tweezers.
  • Make sure to not loosen or remove the black trigger stopper.

With the trigger module out of the way you will then remove the metal piece that is located behind the directional switch and has the spring attached to it.

Do this by simply pulling up on the metal with your fingers or your tweezers.

Make sure to not loosen or remove the black trigger stopper.

Step 5

  • The black directional switch can now be freely removed.

The black directional switch can now be freely removed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Tyler Yurina

Member since: 02/01/2016

407 Reputation

                                      2 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       UW Tacoma, Team 1-2, Rose Winter 2016                        

                                                  Member of UW Tacoma, Team 1-2, Rose Winter 2016 



                    UWT-ROSE-W16S1G2                     


                                            4 Members                     


                                            11 Guides authored