Black And Decker Bdedmt Power Cord Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 minutes

Sections

Armature
2 steps
Power Cord
4 steps

Flags

BackBlack and Decker BDEDMT
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Detach Matrix Attachment

Remember to disconnect the device from all external power sources.
To detach the matrix attachment piece, press down on the attachment release button located at the top of the device.
Leaving your finger pressed down on the button, simply pull on the attachment to release it.

Remember to disconnect the device from all external power sources.

To detach the matrix attachment piece, press down on the attachment release button located at the top of the device.

Leaving your finger pressed down on the button, simply pull on the attachment to release it.

1024

Step 2

              Remove Mounting Hardware

Using a JIS 1 screwdriver, unscrew seven 19mm outer screws located on the armature.
Using the same screwdriver, unscrew the 12mm outer screw located on the armature.

Using a JIS 1 screwdriver, unscrew seven 19mm outer screws located on the armature.

Using the same screwdriver, unscrew the 12mm outer screw located on the armature.

Step 3

              Mounting Bracket

Using the T-handle screwdriver with the JIS 1 bit, unscrew the two lower black 12mm screws.

Using the T-handle screwdriver with the JIS 1 bit, unscrew the two lower black 12mm screws.

Step 4

There will be a white cord that runs from the power cord base to the circuit board located slightly above.
Use the tweezers to detach the entire white cord and blue connection piece as a whole from the circuit board.

There will be a white cord that runs from the power cord base to the circuit board located slightly above.

Use the tweezers to detach the entire white cord and blue connection piece as a whole from the circuit board.

Step 5

              Trigger Assembly

Physically pull up on the trigger device and remove it from the armature.
Flip trigger device over onto its back.

Physically pull up on the trigger device and remove it from the armature.

Flip trigger device over onto its back.

Step 6

              Wire Removal

There is a screw labeled 3 located on the bottom left of the back of the trigger device.
Use a JIS 0 screwdriver to remove screw.
Gently tug on the black wire to pull the wire out of the device.
Now the power cord will be completely removed from the device.

There is a screw labeled 3 located on the bottom left of the back of the trigger device.

Use a JIS 0 screwdriver to remove screw.

Gently tug on the black wire to pull the wire out of the device.

Now the power cord will be completely removed from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 7 other contributors

                    cayla dahl

Member since: 02/01/2016

247 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       UW Tacoma, Team 1-2, Rose Winter 2016                        

                                                  Member of UW Tacoma, Team 1-2, Rose Winter 2016 



                    UWT-ROSE-W16S1G2                     


                                            4 Members                     


                                            11 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team