Difficulty

Moderate

Steps

10

Time Required

                          15 minutes

Sections

2

  • Chassis
  • 4 steps
  • Holder Brush and Spring
  • 6 steps

Flags

0

  • BackBlack and Decker BDERO100

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Chassis
  • Use the nylon spudger to remove the rubber ring from the filter attachment section.
  • The easiest way to do this is to place the spudger sideways and pulling out the ring.

Use the nylon spudger to remove the rubber ring from the filter attachment section.

The easiest way to do this is to place the spudger sideways and pulling out the ring.

1024

Step 2

  • Use the TR20 Torx Security bit driver to unscrew the five 18.75mm Phillips screws from the warning label side of the chassis.

Use the TR20 Torx Security bit driver to unscrew the five 18.75mm Phillips screws from the warning label side of the chassis.

Step 3

  • Grab the plastic opening tool and place it on the separation line between both sides of the chassis.
  • Separate both sides and open the device.
  • Be careful not to lose or detach any internal parts while opening the sander.

Grab the plastic opening tool and place it on the separation line between both sides of the chassis.

Separate both sides and open the device.

Be careful not to lose or detach any internal parts while opening the sander.

Step 4

  • Hold the chassis and separate it from the device.

Hold the chassis and separate it from the device.

Step 5

              Holder Brush and Spring
  • Use the bit driver with the JIS - J1 bit to remove the two 12.5 mm phillips screws holding the cord clamp to the chassis.

Use the bit driver with the JIS - J1 bit to remove the two 12.5 mm phillips screws holding the cord clamp to the chassis.

Step 6

  • With yout hands, hold and separate the power button from the external case by pulling gently.

With yout hands, hold and separate the power button from the external case by pulling gently.

Step 7

  • Identify the white cables connected to the holder brush and spring.

Identify the white cables connected to the holder brush and spring.

Step 8

  • Hold the motor and gently pull to remove from chassis.

Hold the motor and gently pull to remove from chassis.

Step 9

  • Remove the wire connected to the brush holder from the motor by pulling gently.

Remove the wire connected to the brush holder from the motor by pulling gently.

Step 10

  • Remove the wire connected to the brush holder from the motor by pulling gently.
  • Make a note of where each wire should be, you will avoid making wiring mistakes when assembling the device.

Make a note of where each wire should be, you will avoid making wiring mistakes when assembling the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Irene Zubillaga

Member since: 02/10/2016

617 Reputation

                                      5 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       USF Tampa, Team 1-5, Sullivan Spring 2016                        

                                                  Member of USF Tampa, Team 1-5, Sullivan Spring 2016 



                    USFT-SULLIVAN-S16S1G5                     


                                            4 Members                     


                                            6 Guides authored