Difficulty
Very easy
Steps
4
Time Required
5 minutes
Sections
1
- Hook and Loop System
- 4 steps
Flags
0
BackBlack and Decker BDERO100
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Hook and Loop System
- Remove the sanding paper from the velcro.
Remove the sanding paper from the velcro.
1024
Step 2
- Select the JIS - J1 bit or the most appropriate bit to match the screws for your model.
Select the JIS - J1 bit or the most appropriate bit to match the screws for your model.
Step 3
- Use the Bit Driver to take off the four 12.5 mm Phillips screws at the base of the hook-and-loop system.
- Be careful not to lose the lock washers (black rings).
Use the Bit Driver to take off the four 12.5 mm Phillips screws at the base of the hook-and-loop system.
Be careful not to lose the lock washers (black rings).
Step 4
- Once all screws and washers have been removed, hold the hook and loop system and separate it from the device.
Once all screws and washers have been removed, hold the hook and loop system and separate it from the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Christian Moss
Member since: 02/10/2016
101 Reputation
1 Guide authored
Badges:
3
Team
USF Tampa, Team 1-5, Sullivan Spring 2016
Member of USF Tampa, Team 1-5, Sullivan Spring 2016
USFT-SULLIVAN-S16S1G5
4 Members
6 Guides authored
