Difficulty

Moderate

Steps

9

Time Required

                          15 minutes

Sections

2

  • Chassis
  • 4 steps
  • Power Button
  • 5 steps

Flags

0

  • BackBlack and Decker BDERO100

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Chassis
  • Use the nylon spudger to remove the rubber ring from the filter attachment section.
  • The easiest way to do this is to place the spudger sideways and pulling out the ring.

Use the nylon spudger to remove the rubber ring from the filter attachment section.

The easiest way to do this is to place the spudger sideways and pulling out the ring.

1024

Step 2

  • Use the TR20 Torx Security bit driver to unscrew the five 18.75mm Phillips screws from the warning label side of the chassis.

Use the TR20 Torx Security bit driver to unscrew the five 18.75mm Phillips screws from the warning label side of the chassis.

Step 3

  • Grab the plastic opening tool and place it on the separation line between both sides of the chassis.
  • Separate both sides and open the device.
  • Be careful not to lose or detach any internal parts while opening the sander.

Grab the plastic opening tool and place it on the separation line between both sides of the chassis.

Separate both sides and open the device.

Be careful not to lose or detach any internal parts while opening the sander.

Step 4

  • Hold the chassis and separate it from the device.

Hold the chassis and separate it from the device.

Step 5

              Power Button
  • Hold the power button and pull it out of the chassis.

Hold the power button and pull it out of the chassis.

Step 6

  • Select the cable that connects to the power button.

Select the cable that connects to the power button.

Step 7

  • Expose the cable and lock system by peeling off the electric cover.
  • When attaching the new power cord you will need to make sure to cover this lock system with electrical tape.

Expose the cable and lock system by peeling off the electric cover.

When attaching the new power cord you will need to make sure to cover this lock system with electrical tape.

Step 8

  • Push the security pin with the plastic spudger and simultaneously, pull gently on the cable to separate it from the button

Push the security pin with the plastic spudger and simultaneously, pull gently on the cable to separate it from the button

Step 9

  • Detach the black wire connected to the power button from the motor. To do this, gently pull the cable while holding the power button.

Detach the black wire connected to the power button from the motor. To do this, gently pull the cable while holding the power button.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Irene Zubillaga

Member since: 02/10/2016

617 Reputation

                                      5 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       USF Tampa, Team 1-5, Sullivan Spring 2016                        

                                                  Member of USF Tampa, Team 1-5, Sullivan Spring 2016 



                    USFT-SULLIVAN-S16S1G5                     


                                            4 Members                     


                                            6 Guides authored