Difficulty

Moderate

Steps

7

Time Required

                          5 - 10 minutes

Sections

2

  • Blender Base
  • 5 steps
  • Motor Fan
  • 2 steps

Flags

4

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackBlack and Decker BL3000S

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Blender Base
  • Before disassembling the blender base, make sure the blender disconnected from any power outlet.
  • Lift the jar straight up from the base without tilting the jar.

Before disassembling the blender base, make sure the blender disconnected from any power outlet.

Lift the jar straight up from the base without tilting the jar.

1024

Step 2

  • Remove the top three 1/4 inch base screws using a Philip’s head screwdriver.

Remove the top three 1/4 inch base screws using a Philip’s head screwdriver.

Step 3

  • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.
  • This provides access to the base screws beneath.

Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

This provides access to the base screws beneath.

Step 4

  • Remove the following screws that secure the top and bottom halves of the base.
  • One 1/4 Phillips screw
  • One TA-20 screw
  • Both screwdrivers must have a minimum of a three inch shank (length).
  • Screwdrivers with extenders will not fit down the access holes.

Remove the following screws that secure the top and bottom halves of the base.

One 1/4 Phillips screw

One TA-20 screw

Both screwdrivers must have a minimum of a three inch shank (length).

Screwdrivers with extenders will not fit down the access holes.

Step 5

  • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

Step 6

              Motor Fan
  • Using pliers, remove the top nut from the fan and remove the washer.
  • Use a small towel to hold the fan in place. This makes taking off the nut easier to do.

Using pliers, remove the top nut from the fan and remove the washer.

Use a small towel to hold the fan in place. This makes taking off the nut easier to do.

Step 7

  • Lift the fan blades from the blender base.

Lift the fan blades from the blender base.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 3 other contributors 


                    Andrew

Member since: 10/04/2012

209 Reputation

                                      4 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Cal Poly, Team 6-34, Regan Fall 2012                        

                                                  Member of Cal Poly, Team 6-34, Regan Fall 2012 



                    CPSU-REGAN-F12S6G34                     


                                            4 Members                     


                                            6 Guides authored