Black And Decker Bv2500 Type 4 Power Cord Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          15 - 20 minutes

Sections

Clamshell (Black Outer Casing)
2 steps
Power Cord
4 steps

Flags

BackBlack and Decker BV2500 Type 4
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Clamshell (Black Outer Casing)

Using a Phillips #2 screwdriver, remove the six 20 mm screws in the black plastic casing (clamshell).

Using a Phillips #2 screwdriver, remove the six 20 mm screws in the black plastic casing (clamshell).

1024

Step 2

Using your hands, remove the blower tube and clamshell.
To remove the clamshell, pull apart starting from the bottom until it is pulled out from the notches. Then slide it out away from the device.

Using your hands, remove the blower tube and clamshell.

To remove the clamshell, pull apart starting from the bottom until it is pulled out from the notches. Then slide it out away from the device.

Step 3

              Power Cord

Using a Phillips #2 screwdriver, remove the ten 20 mm screws in the orange casing.
Use your hands to lift off the side of the orange casing with the screws facing you.

Using a Phillips #2 screwdriver, remove the ten 20 mm screws in the orange casing.

Use your hands to lift off the side of the orange casing with the screws facing you.

Step 4

Locate the switch.
Remove the 2 black and white wires with blue casings from the switch.
Using your hands, push in the sides of the switch and slide out the wires.

Locate the switch.

Remove the 2 black and white wires with blue casings from the switch.

Using your hands, push in the sides of the switch and slide out the wires.

Step 5

Remove the two 20 mm Phillips #2 screws that are holding in the power cord (located at the bottom of the leaf hog).

Remove the two 20 mm Phillips #2 screws that are holding in the power cord (located at the bottom of the leaf hog).

Step 6

Slide the power cord support off the power cord in the direction of the leads.
Use your hands to pull the power cord out of the device with the lead end coming out last.

Slide the power cord support off the power cord in the direction of the leads.

Use your hands to pull the power cord out of the device with the lead end coming out last.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors

                    Angelica Chow

Member since: 01/25/2014

409 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 9-29, Maness Winter 2014                        

                                                  Member of Cal Poly, Team 9-29, Maness Winter 2014 



                    CPSU-MANESS-W14S9G29                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team