Difficulty
Very easy
Steps
3
Time Required
5 - 10 minutes
Sections
2
- Clamshell (Black Outer Casing)
- 2 steps
- Powerhead Assembly
- 1 step
Flags
0
BackBlack and Decker BV2500 Type 4
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Clamshell (Black Outer Casing)
- Using a Phillips #2 screwdriver, remove the six 20 mm screws in the black plastic casing (clamshell).
Using a Phillips #2 screwdriver, remove the six 20 mm screws in the black plastic casing (clamshell).
1024
Step 2
- Using your hands, remove the blower tube and clamshell.
- To remove the clamshell, pull apart starting from the bottom until it is pulled out from the notches. Then slide it out away from the device.
Using your hands, remove the blower tube and clamshell.
To remove the clamshell, pull apart starting from the bottom until it is pulled out from the notches. Then slide it out away from the device.
Step 3
Powerhead Assembly
- The powerhead assembly is the entire orange part of the device.
- Replace it with a new powerhead assembly.
The powerhead assembly is the entire orange part of the device.
Replace it with a new powerhead assembly.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Angelica Chow
Member since: 01/25/2014
409 Reputation
3 Guides authored
Badges:
8
+5 more badges
Team
Cal Poly, Team 9-29, Maness Winter 2014
Member of Cal Poly, Team 9-29, Maness Winter 2014
CPSU-MANESS-W14S9G29
4 Members
5 Guides authored