Difficulty
Very easy
Steps
5
Time Required
5 minutes
Sections
1
- Nozzle Brush
- 5 steps
Flags
0
BackBlack and Decker HHVI325JR22
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Nozzle Brush
- Lift Nozzle Brush until it clicks into fully erect position.
Lift Nozzle Brush until it clicks into fully erect position.
1024
Step 2
- Apply a gentle, equal pressure outward, to the inside of both brush legs.
Apply a gentle, equal pressure outward, to the inside of both brush legs.
Step 3
- Remove one of the leg prongs from the hole it is inserted into.
Remove one of the leg prongs from the hole it is inserted into.
Step 4
- Rotate the free leg forwards or backwards from the hole.
- This relieves the pressure from the inside of the legs allowing you to freely remove the last leg from its hole.
Rotate the free leg forwards or backwards from the hole.
This relieves the pressure from the inside of the legs allowing you to freely remove the last leg from its hole.
Step 5
- Check each leg hole for debris and clear whats needed.
- Insert a leg of the new brush into the correct hole, so the brush will click into its erect position.
- Slide the other leg into its respective hole.
Check each leg hole for debris and clear whats needed.
Insert a leg of the new brush into the correct hole, so the brush will click into its erect position.
Slide the other leg into its respective hole.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Jacob
Member since: 03/15/2017
101 Reputation
1 Guide authored
Badges:
2
Team
UMass Dartmouth, Team S6-G1, Isaacson Spring 2017
Member of UMass Dartmouth, Team S6-G1, Isaacson Spring 2017
UMASSD-ISAACSON-S17S6G1
4 Members
8 Guides authored
