Difficulty
Easy
Steps
6
Time Required
10 - 15 minutes
Sections
1
- Motor
- 6 steps
Flags
0
BackBlack and Decker Vacuum
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Motor
- Press the button above the dustbin and separate the dustbin from the handle.
Press the button above the dustbin and separate the dustbin from the handle.
1024
Step 2
- Remove five screws from the handle using a Phillips #1 screwdriver.
Remove five screws from the handle using a Phillips #1 screwdriver.
Step 3
- Pry open the two halves of the case.
Pry open the two halves of the case.
Step 4
- Lift the motor and circuitry out of the plastic casing using your hands.
- Pry out the PCB using a nylon spudger.
Lift the motor and circuitry out of the plastic casing using your hands.
Pry out the PCB using a nylon spudger.
Step 5
- Separate the motor leads from the PCB with a pair of needle nose pliers.
- Be careful not to break the new motor leads as they can be fragile.
Separate the motor leads from the PCB with a pair of needle nose pliers.
Be careful not to break the new motor leads as they can be fragile.
Step 6
- Using a pair of pliers, insert the metal prongs of the new motor into the PCB.
Using a pair of pliers, insert the metal prongs of the new motor into the PCB.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Ethan Hemstreet
Member since: 09/08/2021
172 Reputation
1 Guide authored
Badges:
6
+3 more badges
Team
Embry-Riddle Aeronautical University, Team 1-8, Rauch Fall 2021
Member of Embry-Riddle Aeronautical University, Team 1-8, Rauch Fall 2021
ERAU-RAUCH-F21S1G8
2 Members
1 Guide authored
