Difficulty
Easy
Steps
13
Time Required
20 - 25 minutes
Sections
1
- Black and Decker G48TD Disassembly
- 13 steps
Flags
3
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
Needs More Images
A few more images would make this guide’s procedures crystal clear.
Better Introduction
Improve this guide by completing or revising its introduction.
BackBlack and Decker G48TD
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Model Name: G48TD
This guide aims to disassemble the device into its fundamental components.
Safety warnings:
- Do not operate on device while it is receiving powerBe careful when bending sharp metal tabs
No special skills are required for following this guide
What you need
Step 1
Black and Decker G48TD Disassembly
- Open the grill.
Open the grill.
1024
Step 2
- Remove the top and bottom griddle plates.
Remove the top and bottom griddle plates.
Step 3
- Use a pair of Large Needle Nosed Pliers to twist the metal tabs holding the plate housing the bottom heating element connections and remove the plate.
Use a pair of Large Needle Nosed Pliers to twist the metal tabs holding the plate housing the bottom heating element connections and remove the plate.
Step 4
- Use a pair of Large Needle Nosed Pliers to twist the metal tabs holding the plate housing the top heating element connections and remove the plates.
Use a pair of Large Needle Nosed Pliers to twist the metal tabs holding the plate housing the top heating element connections and remove the plates.
Step 5
- Use pliers to twist the metal tabs holding down the thermostat housing.
Use pliers to twist the metal tabs holding down the thermostat housing.
Step 6
- Use a 4 mm Flathead screwdriver to remove the 11.4 mm screw in the back of the thermostat housing.
Use a 4 mm Flathead screwdriver to remove the 11.4 mm screw in the back of the thermostat housing.
Step 7
- Lift up the thermostat housing and detach it from the temperature control arm, then remove the washers at the end of the temperature control arm.
Lift up the thermostat housing and detach it from the temperature control arm, then remove the washers at the end of the temperature control arm.
Step 8
- Remove the thermostat housing.
Remove the thermostat housing.
Step 9
- Remove the thermostat housing springs.
Remove the thermostat housing springs.
Step 10
- Bend up the brackets holding down the heating elements.
Bend up the brackets holding down the heating elements.
Step 11
- Remove the heating elements from their respective housings (the bottom one is not able to be removed completely as it is fused to a piece of metal).
Remove the heating elements from their respective housings (the bottom one is not able to be removed completely as it is fused to a piece of metal).
Step 12
- Remove the housing from the wiring along the bottom of the grill.
Remove the housing from the wiring along the bottom of the grill.
Step 13
- The device is fully disassembled!
The device is fully disassembled!
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Connor White
Member since: 09/16/2021
267 Reputation
1 Guide authored
Badges:
4
+1 more badge
Team
Tufts University School of Engineering, Team 1-7, Bell Fall 2021
Member of Tufts University School of Engineering, Team 1-7, Bell Fall 2021
TUFTS-BELL-F21S1G7
2 Members
1 Guide authored
