Difficulty

Moderate

Steps

7

Time Required

                          10 minutes

Sections

3

  • Housing Disassembly
  • 2 steps
  • Power Cord
  • 3 steps
  • Trigger
  • 2 steps

Flags

0

  • BackBlack and Decker JS660

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Housing Disassembly
  • Remove the nine torx 15.875mm screws on the front of the jigsaw using a T-15 torx screwdriver.

Remove the nine torx 15.875mm screws on the front of the jigsaw using a T-15 torx screwdriver.

1024

Step 2

  • By separating the two housing halves, carefully remove the top plate.

By separating the two housing halves, carefully remove the top plate.

Step 3

              Power Cord
  • Remove the two 12.7mm phillips head screws holding the power cord in place with a PH2 Phillips head screwdriver.

Remove the two 12.7mm phillips head screws holding the power cord in place with a PH2 Phillips head screwdriver.

Step 4

  • Remove the two 6.35mm flat head screws on the trigger with a 2.5 flat head screwdriver to disconnect the white and black cords.

Remove the two 6.35mm flat head screws on the trigger with a 2.5 flat head screwdriver to disconnect the white and black cords.

Step 5

  • Gently remove the black and white cord from the trigger assembly.

Gently remove the black and white cord from the trigger assembly.

Step 6

              Trigger
  • Use tweezers to press down on these tabs on the trigger assembly.
  • While the tab is depressed, the cord can be pulled out of the housing by using a moderate amount of force.
  • Each cord needs to be done separately.

Use tweezers to press down on these tabs on the trigger assembly.

While the tab is depressed, the cord can be pulled out of the housing by using a moderate amount of force.

Each cord needs to be done separately.

Step 7

  • Remove pink wires from trigger assembly.

Remove pink wires from trigger assembly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    matt murray

Member since: 01/27/2017

664 Reputation

                                      6 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Cal Poly, Team 22-9, Maness Winter 2017                        

                                                  Member of Cal Poly, Team 22-9, Maness Winter 2017 



                    CPSU-MANESS-W17S22G9                     


                                            4 Members                     


                                            7 Guides authored