Black And Decker Ldx172C Led Power Indicator Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          40 minutes - 1 hour

Sections

LED Power Indicator
4 steps

Flags

BackBlack and Decker LDX172C
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              LED Power Indicator

Before beginning, make sure the motor direction switch is in the neutral position.
Place the drill on the work surface with the chuck facing downward. Locate and remove the two #2 X 10mm Phillips screws located right of the motor.

Before beginning, make sure the motor direction switch is in the neutral position.

Place the drill on the work surface with the chuck facing downward. Locate and remove the two #2 X 10mm Phillips screws located right of the motor.

1024

Step 2

Rotate the drill to it’s left side - the chuck should be facing rightward. Locate and remove the eight #2 X 5mm Phillips fasteners from the body of the drill.

Rotate the drill to it’s left side - the chuck should be facing rightward. Locate and remove the eight #2 X 5mm Phillips fasteners from the body of the drill.

Step 3

Carefully remove the right half of the body from the drill.
The trigger mechanism is spring loaded and may eject from the drill when the body is removed.
Locate the LED power indicator located just above the battery pack.

Carefully remove the right half of the body from the drill.

The trigger mechanism is spring loaded and may eject from the drill when the body is removed.

Locate the LED power indicator located just above the battery pack.

Step 4

The LED is located on a small surface mount circuit board that easily slides out of its mounting location.
The LED is removed by freeing the solder joints on the bottom side of the circuit board.
Place the new LED through the same holes and re-solder it.
To reassemble repeat directions in reverse order.

The LED is located on a small surface mount circuit board that easily slides out of its mounting location.

The LED is removed by freeing the solder joints on the bottom side of the circuit board.

Place the new LED through the same holes and re-solder it.

To reassemble repeat directions in reverse order.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Casey

Member since: 02/13/2016

260 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       IUPUI, Team 3-3, Wilson Spring 2016                        

                                                  Member of IUPUI, Team 3-3, Wilson Spring 2016 



                    IUPUI-WILSON-S16S3G3                     


                                            4 Members                     


                                            6 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team