Black And Decker Ldx172C Trigger Switch Replacement Repair Guide

Difficulty

Moderate

Steps

4

Time Required

                          40 minutes - 1 hour            

Sections

1

• Trigger Switch
• 4 steps

Flags

0

• BackBlack and Decker LDX172C

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Trigger Switch               

• Before beginning, make sure the motor direction switch is in the neutral position.
• Place the drill on the work surface with the chuck facing downward. Locate and remove the two #2 X 10mm Phillips screws located right of the motor.

Before beginning, make sure the motor direction switch is in the neutral position.

Place the drill on the work surface with the chuck facing downward. Locate and remove the two #2 X 10mm Phillips screws located right of the motor.

1024

Step 2

• Rotate the drill to it’s left side - the chuck should be facing to the right. Locate and remove the eight #2 X 5mm Phillips fasteners from the body of the drill.

Rotate the drill to it’s left side - the chuck should be facing to the right. Locate and remove the eight #2 X 5mm Phillips fasteners from the body of the drill.

Step 3

• Carefully remove the right half of the body from the drill.
• The trigger mechanism is spring loaded and may eject from the drill when the body is removed.

Carefully remove the right half of the body from the drill.

The trigger mechanism is spring loaded and may eject from the drill when the body is removed.

Step 4

• Remove trigger from drill by pulling the mechanism directly up off the holding pins.
• The leads from the switch are removed by using a heating the solder until they come free.
• Re-solder the leads to the new switch.
• Repeat directions in reverse to reassemble.

Remove trigger from drill by pulling the mechanism directly up off the holding pins.

The leads from the switch are removed by using a heating the solder until they come free.

Re-solder the leads to the new switch.

Repeat directions in reverse to reassemble.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 6 other contributors 

                    jakebontragersinger                     

Member since: 02/13/2016

119 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       IUPUI, Team 3-3, Wilson Spring 2016                        

                                                  Member of IUPUI, Team 3-3, Wilson Spring 2016 



                    IUPUI-WILSON-S16S3G3                     


                                            4 Members                     


                                            6 Guides authored