Difficulty

Difficult

Steps

8

Time Required

                          30 minutes

Sections

3

  • Orange Casing
  • 4 steps
  • Handle
  • 2 steps
  • Charging Port
  • 2 steps

Flags

1

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

  • BackBlack and Decker LI2000

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Orange Casing
  • Remove the following five screws
  • Three 20 mm Phillips #1 screws
  • One 10 mm #000 Phillips screw
  • One 13 mm Phillips 31 screw
  • When you remove the 13 mm screw, the spring may pop out of the screwdriver. Point the backside of the screwdriver away from your face and others.

Remove the following five screws

Three 20 mm Phillips #1 screws

One 10 mm #000 Phillips screw

One 13 mm Phillips 31 screw

When you remove the 13 mm screw, the spring may pop out of the screwdriver. Point the backside of the screwdriver away from your face and others.

1024

Step 2

  • Remove the black sticker with recycling information.

Remove the black sticker with recycling information.

Step 3

  • Use your fingers or a plastic opening tool to pry the casing apart.

Use your fingers or a plastic opening tool to pry the casing apart.

Step 4

  • Remove the plastic slider by picking it up off the screwdriver.
  • You may consider leaving half of the casing on the screwdriver to make handling the screwdriver easier.

Remove the plastic slider by picking it up off the screwdriver.

You may consider leaving half of the casing on the screwdriver to make handling the screwdriver easier.

Step 5

              Handle
  • Remove the four 15mm Phillips #1 screws.

Remove the four 15mm Phillips #1 screws.

Step 6

  • Use a plastic opening tool to pry the casing apart.

Use a plastic opening tool to pry the casing apart.

Step 7

              Charging Port
  • Pull the charging port and circuit board away from the casing.

Pull the charging port and circuit board away from the casing.

Step 8

  • Refer to the Soldering Technique Guide to remove the wires at the charging port by heating the existing solder on the contacts.
  • Be sure to keep track of which wire was attached to each lead.

Refer to the Soldering Technique Guide to remove the wires at the charging port by heating the existing solder on the contacts.

Be sure to keep track of which wire was attached to each lead.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Katherine Simmons

Member since: 02/08/2016

711 Reputation

                                      5 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       IUPUI, Team 1-3, Baechle Spring 2016                        

                                                  Member of IUPUI, Team 1-3, Baechle Spring 2016 



                    IUPUI-BAECHLE-S16S1G3                     


                                            4 Members                     


                                            10 Guides authored