Black And Decker Pivot Max Pivot Lock Button Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          25 minutes            

Sections

2

• Battery
• 5 steps
• Pivot Lock Button
• 2 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

• BackBlack and Decker Pivot MAX

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Press in and hold the release button.
• Rotate the dust filter chamber counter-clockwise.
• Remove the dust filter chamber.

Press in and hold the release button.

Rotate the dust filter chamber counter-clockwise.

Remove the dust filter chamber.

1024

Step 2

• Remove the two 10 mm screws from the motor casing with a Phillips #1 screwdriver.

Remove the two 10 mm screws from the motor casing with a Phillips #1 screwdriver.

Step 3

• Pull the battery cover up and then slide it away from the motor to remove.

Pull the battery cover up and then slide it away from the motor to remove.

Step 4

• Remove the battery unit by pulling it out of the main body.

Remove the battery unit by pulling it out of the main body.

Step 5

• Disconnect the quick connect wire harness that connects the motor and battery located in the battery storage compartment.

Disconnect the quick connect wire harness that connects the motor and battery located in the battery storage compartment.

Step 6

              Pivot Lock Button               

• Remove the handle cover by removing the three PH1 20mm screws

Remove the handle cover by removing the three PH1 20mm screws

Step 7

• Pull out the pivot lock button.

Pull out the pivot lock button.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 5 other contributors 

                    Jesse Sipes                     

Member since: 11/06/2017

538 Reputation

                                      2 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges                           

Team

                       IUPUI, Team S5-G6, Baechle Fall 2017                        

                                                  Member of IUPUI, Team S5-G6, Baechle Fall 2017 



                    IUPUI-BAECHLE-F17S5G6                     


                                            3 Members                     


                                            5 Guides authored                     

Darcy Lee - Feb 9, 2019

Reply

How does the fan blade come off

Brad Kik - Mar 18, 2019

Darcy, there are a lot more steps for that. You have to pry off the grey ring around the motor housing, then unscrew the housing. Once you are able to remove the motor assembly from the rest of the vacuum, you flip it over and the fan blade is a flat disk mounted on the opposite side of the motor drive. Carefully pry it out. (A step by step with pics would help make a lot more sense of this.)

George Chryssanthou - Mar 31, 2020

Reply

The thermal fuse cannot get it from B&D.

I have a bad one the vacuum starts and stops. Where can I buy the fuse?

paddy - Jun 9, 2021

Reply

@fixit_18 you cannot replace the fuse. This device is not intended to be repaired. This tutorial is useless as parts are not available. Anyone who has one of theses knows it and will likely have to fabricate their own replacement parts…… I need a battery and will be building one from scratch….