Difficulty

Moderate

Steps

9

Time Required

                          15 minutes

Sections

3

  • Battery
  • 5 steps
  • Pivot Lock Button
  • 2 steps
  • Power Switch
  • 2 steps

Flags

2

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackBlack and Decker Pivot MAX

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

This guide will take you through the steps of removing and re-assembling key components of the Black and Decker Pivot MAX to allow you to replace the power switch. Tools you will need for this project will be a Phillips head screwdriver and a soldering iron.

What you need

Step 1

              Battery
  • Press in and hold the release button.
  • Rotate the dust filter chamber counter-clockwise.
  • Remove the dust filter chamber.

Press in and hold the release button.

Rotate the dust filter chamber counter-clockwise.

Remove the dust filter chamber.

1024

Step 2

  • Remove the two 10 mm screws from the motor casing with a Phillips #1 screwdriver.

Remove the two 10 mm screws from the motor casing with a Phillips #1 screwdriver.

Step 3

  • Pull the battery cover up and then slide it away from the motor to remove.

Pull the battery cover up and then slide it away from the motor to remove.

Step 4

  • Remove the battery unit by pulling it out of the main body.

Remove the battery unit by pulling it out of the main body.

Step 5

  • Disconnect the quick connect wire harness that connects the motor and battery located in the battery storage compartment.

Disconnect the quick connect wire harness that connects the motor and battery located in the battery storage compartment.

Step 6

              Pivot Lock Button
  • Remove the handle cover by removing the three PH1 20mm screws

Remove the handle cover by removing the three PH1 20mm screws

Step 7

  • Pull out the pivot lock button.

Pull out the pivot lock button.

Step 8

              Power Switch
  • Lift the battery tray after removing the screws
  • Remove the handle parts from the handle area.

Lift the battery tray after removing the screws

Remove the handle parts from the handle area.

Step 9

  • Pull the power switch out softly.
  • Desolder the wires from the old power switch to the new one.
  • Check out our How To Solder and Desolder Connections guide if you need any help!

Pull the power switch out softly.

Desolder the wires from the old power switch to the new one.

Check out our How To Solder and Desolder Connections guide if you need any help!

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Avery Hanulcik

Member since: 09/15/2020

316 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       The Citadel Military College of South Carolina, Team S1-G8, Eggleston Fall 2020                        

                                                  Member of The Citadel Military College of South Carolina, Team S1-G8, Eggleston Fall 2020 



                    CMCSC-EGGLESTON-F20S1G8                     


                                            3 Members                     


                                            3 Guides authored