Difficulty

Easy

Steps

6

Time Required

                          10 - 15 minutes

Sections

2

  • Drill
  • 2 steps
  • LED light
  • 4 steps

Flags

1

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

  • BackBlack and Decker Pivot Plus PD600

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Drill
  • Remove the nine 15mm Philips #1 screws
  • Remove the two 12.5mm Philips #1 screws
  • Remove the two 10mm Philips #1 screws

Remove the nine 15mm Philips #1 screws

Remove the two 12.5mm Philips #1 screws

Remove the two 10mm Philips #1 screws

1024

Step 2

  • Lift one side of the drill casing off of the drill. Note that the drill casing consists of two pieces on either side of the drill.

Lift one side of the drill casing off of the drill. Note that the drill casing consists of two pieces on either side of the drill.

Step 3

              LED light
  • In order to replace the small LED light look below the motor at the front of the drill to find a black plastic piece with two very skinny wires emanating from it.
  • The black plastic piece is the housing. The light is placed inside this black plastic housing.

In order to replace the small LED light look below the motor at the front of the drill to find a black plastic piece with two very skinny wires emanating from it.

The black plastic piece is the housing. The light is placed inside this black plastic housing.

Step 4

  • Pull the black plastic piece up out of the slot in the drill body that it fits into.

Pull the black plastic piece up out of the slot in the drill body that it fits into.

Step 5

  • The light itself can be easily removed from the black plastic piece by simply pulling it out.
  • One of the metal “legs” on the LED is longer than the other and it must be placed in the black plastic housing in the same manner it was removed or it will not work.

The light itself can be easily removed from the black plastic piece by simply pulling it out.

One of the metal “legs” on the LED is longer than the other and it must be placed in the black plastic housing in the same manner it was removed or it will not work.

Step 6

  • Take your new LED and slide it back into the plastic housing in the same orientation as the old LED.

Take your new LED and slide it back into the plastic housing in the same orientation as the old LED.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 5 other contributors 


                    justin boyd

Member since: 05/13/2013

131 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team 4-15, Maness Spring 2013                        

                                                  Member of Cal Poly, Team 4-15, Maness Spring 2013 



                    CPSU-MANESS-S13S4G15                     


                                            5 Members                     


                                            6 Guides authored