Difficulty
Easy
Steps
4
Time Required
5 - 10 minutes
Sections
2
- Open the Outer Drill Case
- 2 steps
- Actuator Fwd/Rev
- 2 steps
Flags
0
BackBlack and Decker PS1800
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Open the Outer Drill Case
- Lay the drill on its side, assuring that the screw holes are facing upwards.
- Remove seven 12 mm screws using a Phillips #00 screwdriver.
Lay the drill on its side, assuring that the screw holes are facing upwards.
Remove seven 12 mm screws using a Phillips #00 screwdriver.
1024
Step 2
- Separate the outer drill case to expose the components and switch.
Separate the outer drill case to expose the components and switch.
Step 3
Actuator Fwd/Rev
- Start separating the outer shell into two parts.
- You will find the Fwd/Rev actuator on the right side of the drill, underneath the motor.
Start separating the outer shell into two parts.
You will find the Fwd/Rev actuator on the right side of the drill, underneath the motor.
Step 4
- Carefully remove the actuator from the drill.
- Replace the new actuator by inserting it the same way you took it out.
Carefully remove the actuator from the drill.
Replace the new actuator by inserting it the same way you took it out.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 13 other contributors
Hamza Nawaz
Member since: 11/20/2016
247 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
IUPUI, Team 2-3, Baechle Fall 2016
Member of IUPUI, Team 2-3, Baechle Fall 2016
IUPUI-BAECHLE-F16S2G3
5 Members
6 Guides authored
