Difficulty
Moderate
Steps
5
Time Required
3 minutes
Sections
2
- Open the Outer Drill Case
- 2 steps
- Disconnect Motor
- 3 steps
Flags
0
BackBlack and Decker PS1800
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Open the Outer Drill Case
- Lay the drill on its side, assuring that the screw holes are facing upwards.
- Remove seven 12 mm screws using a Phillips #00 screwdriver.
Lay the drill on its side, assuring that the screw holes are facing upwards.
Remove seven 12 mm screws using a Phillips #00 screwdriver.
1024
Step 2
- Separate the outer drill case to expose the components and switch.
Separate the outer drill case to expose the components and switch.
Step 3
Disconnect Motor
- Locate the motor at the top left hand corner.
- Carefully disconnect the red and black wires attached to the motor.
Locate the motor at the top left hand corner.
Carefully disconnect the red and black wires attached to the motor.
Step 4
- Unscrew the motor from the drill’s transmission.
- Detach the transmission carefully, ensuring that the gears remain intact.
Unscrew the motor from the drill’s transmission.
Detach the transmission carefully, ensuring that the gears remain intact.
Step 5
- Remove the motor from the transmission assembly, as pictured.
Remove the motor from the transmission assembly, as pictured.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 7 other contributors
Christian Aldrich
Member since: 10/12/2016
241 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
IUPUI, Team 2-3, Baechle Fall 2016
Member of IUPUI, Team 2-3, Baechle Fall 2016
IUPUI-BAECHLE-F16S2G3
5 Members
6 Guides authored
