Black And Decker Wp900 Exterior Casing Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

Suggest a time??

Sections

Exterior Casing
6 steps

Flags

BackBlack and Decker WP900
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Exterior Casing

Using the plastic tool, detach the handle tab as shown.
Make sure the device is unplugged.

Using the plastic tool, detach the handle tab as shown.

Make sure the device is unplugged.

1024

Step 2

Using the Phillips #1 screwdriver, unscrew all of the screws. There should be 8-30mm screws to remove.
Be sure to keep track of where each screw was placed in the device for later reassembly.

Using the Phillips #1 screwdriver, unscrew all of the screws. There should be 8-30mm screws to remove.

Be sure to keep track of where each screw was placed in the device for later reassembly.

Step 3

Remove the back panel of the external casing, leaving all internal components resting in the front panel.
Remove the black handle from the main external casing.

Remove the back panel of the external casing, leaving all internal components resting in the front panel.

Remove the black handle from the main external casing.

Step 4

Using the Phillips #1 screwdriver, remove the two 22mm screws.
The metal bracket will detach with the two screws.
Using the Flathead 3/32" screwdriver, remove two 22mm screws.

Using the Phillips #1 screwdriver, remove the two 22mm screws.

The metal bracket will detach with the two screws.

Using the Flathead 3/32" screwdriver, remove two 22mm screws.

Step 5

Gently pull the power cord out from the control module.
Remember, when reassembling the device, the black wire should be on the top.

Gently pull the power cord out from the control module.

Remember, when reassembling the device, the black wire should be on the top.

Step 6

Firmly grasping the motor dislodge the internal components from the frontal external casing.
Once the motor has been removed, the external casing can now be replaced.

Firmly grasping the motor dislodge the internal components from the frontal external casing.

Once the motor has been removed, the external casing can now be replaced.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    David Hutchings

Member since: 03/28/2016

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       IUPUI, Team 8-8, Wilson Spring 2016                        

                                                  Member of IUPUI, Team 8-8, Wilson Spring 2016 



                    IUPUI-WILSON-S16S8G8                     


                                            4 Members                     


                                            4 Guides authored

Adam Kinnett - Apr 3, 2016

Hello, this is Adam Kinnett from Group 7. You have done an excellent job on your photos as well as the descriptions and formatting.

**One of your Wiki pages on the search says “Back and Decker”.

Introduction#

What you need#

Team#

Introduction

What you need

Team