Difficulty

Easy

Steps

5

Time Required

                          10 minutes

Sections

1

  • Power Cord
  • 5 steps

Flags

0

  • BackBlack and Decker WP900

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Power Cord
  • Using the plastic tool, detach the handle tab as shown.
  • Make sure the device is unplugged.

Using the plastic tool, detach the handle tab as shown.

Make sure the device is unplugged.

1024

Step 2

  • Using the Philips #1 screwdriver, unscrew all of the screws. There should be 8-30mm screws to remove.
  • Be sure to keep track of where each screw was placed in the device for later reassembly.

Using the Philips #1 screwdriver, unscrew all of the screws. There should be 8-30mm screws to remove.

Be sure to keep track of where each screw was placed in the device for later reassembly.

Step 3

  • Remove the back panel of the external casing, leaving all internal components resting in the front panel.
  • Remove the black handle from the main external casing.

Remove the back panel of the external casing, leaving all internal components resting in the front panel.

Remove the black handle from the main external casing.

Step 4

  • Loosen the power cord and control panel. Using the Phillips #1 screwdriver, remove two 22mm screws.
  • The metal bracket will detach with the two screws.
  • Using the Flathead 3/32" screwdriver, remove two 22mm screws.

Loosen the power cord and control panel. Using the Phillips #1 screwdriver, remove two 22mm screws.

The metal bracket will detach with the two screws.

Using the Flathead 3/32" screwdriver, remove two 22mm screws.

Step 5

  • Gently pull the power cord out from the control module.
  • This is the part to be replaced. Remember to insert the black wire into the top port when installing the new cord.

Gently pull the power cord out from the control module.

This is the part to be replaced. Remember to insert the black wire into the top port when installing the new cord.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Cameron

Member since: 02/15/2016

231 Reputation

                                      2 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       IUPUI, Team 8-8, Wilson Spring 2016                        

                                                  Member of IUPUI, Team 8-8, Wilson Spring 2016 



                    IUPUI-WILSON-S16S8G8                     


                                            4 Members                     


                                            4 Guides authored