Black And Decker Wp900 Power Switch Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 minutes

Sections

Power Switch
7 steps

Flags

BackBlack and Decker WP900
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Power Switch

Using the plastic tool, detach the handle tab as shown.
Make sure the device is unplugged.

Using the plastic tool, detach the handle tab as shown.

Make sure the device is unplugged.

1024

Step 2

Using the Philips #1 screwdriver, unscrew all of the screws. There should be 8-30mm screws to remove.
Be sure to keep track of where each screw was placed in the device for later reassembly.

Using the Philips #1 screwdriver, unscrew all of the screws. There should be 8-30mm screws to remove.

Be sure to keep track of where each screw was placed in the device for later reassembly.

Step 3

Remove the back panel of the external casing, leaving all internal components resting in the front panel.
Remove the black handle from the main external casing.

Remove the back panel of the external casing, leaving all internal components resting in the front panel.

Remove the black handle from the main external casing.

Step 4

Loosen the power cord and control panel. Using the Phillip’s #1 screwdriver, remove two 22mm screws.
The metal bracket will detach with the two screws.
Using the Flathead 3/32" screwdriver, remove two 22mm screws.

Loosen the power cord and control panel. Using the Phillip’s #1 screwdriver, remove two 22mm screws.

The metal bracket will detach with the two screws.

Using the Flathead 3/32" screwdriver, remove two 22mm screws.

Step 5

Gently pull the power cord out from the control module.
Remember, when reassembling the device, the black wire should be on the top

Gently pull the power cord out from the control module.

Remember, when reassembling the device, the black wire should be on the top

Step 6

Firmly grasping the motor, dislodge the internal components from the frontal external casing.
Switch and control panel will be attached to magnet body.

Firmly grasping the motor, dislodge the internal components from the frontal external casing.

Switch and control panel will be attached to magnet body.

Step 7

Remove the switch from the wires.
Gently, pull and release the two wired connections.
The switch can now be replaced. Be sure not to damage the two connections to the control module in the process.

Remove the switch from the wires.

Gently, pull and release the two wired connections.

The switch can now be replaced. Be sure not to damage the two connections to the control module in the process.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Cameron

Member since: 02/15/2016

231 Reputation

                                      2 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       IUPUI, Team 8-8, Wilson Spring 2016                        

                                                  Member of IUPUI, Team 8-8, Wilson Spring 2016 



                    IUPUI-WILSON-S16S8G8                     


                                            4 Members                     


                                            4 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team