Difficulty

Moderate

Steps

7

Time Required

                          15 minutes

Sections

1

  • BlackBerry KeyONE partial Disassembly
  • 7 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackBlackBerry KeyOne

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Remove top cover
  • Carefully remove the top plastic cover. It is held in place by adhesive.

Carefully remove the top plastic cover. It is held in place by adhesive.

1024

Step 2

              Remove top frame
  • Remove the two Philipps #0 screws that hold in place the top of the phone frame and slide it off.

Remove the two Philipps #0 screws that hold in place the top of the phone frame and slide it off.

Step 3

              Remove back cover
  • Remove the back cover. It mostly just clips off, but has some adhesive in the lower area.

Remove the back cover. It mostly just clips off, but has some adhesive in the lower area.

Step 4

              Disconnect Battery
  • Remove the two Philipps #0 screws securing the battery connector and unplug the later.

Remove the two Philipps #0 screws securing the battery connector and unplug the later.

Step 5

  • Remove the 6 Philipps #0 screws securing the lower cover and remove it.
  • Remove the three Philipps #0 screws holding down the bar that secures the two main lego-style plugs and remove it.

Remove the 6 Philipps #0 screws securing the lower cover and remove it.

Remove the three Philipps #0 screws holding down the bar that secures the two main lego-style plugs and remove it.

Step 6

              Remove top cover
  • Remove the three Philipps #0 screws securing the upper cover and remove it.

Remove the three Philipps #0 screws securing the upper cover and remove it.

Step 7

  • Unplug the remaining ribbon cables
  • Remove the last three Philipps #0 screws securing the Motherbard.
  • Now you should be able to replace most components.
  • The screen is held in place from the front by adhesive (or not, in the earlier versions), its cable slides trough the phone to the PCB - It’s the large connector in the middle.
  • The battery is glued to the frame firmly. There are three pultabs located underneath the motherboard.
  • Don’t forget to remove the sim-tray if you’re removing the motherboard.

Unplug the remaining ribbon cables

Remove the last three Philipps #0 screws securing the Motherbard.

Now you should be able to replace most components.

The screen is held in place from the front by adhesive (or not, in the earlier versions), its cable slides trough the phone to the PCB - It’s the large connector in the middle.

The battery is glued to the frame firmly. There are three pultabs located underneath the motherboard.

Don’t forget to remove the sim-tray if you’re removing the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      12 other people completed this guide.

Author

                                      with 2 other contributors 


                    raven

Member since: 09/02/2015

686 Reputation

                                      2 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges