Difficulty

Moderate

Steps

10

Time Required

                          15 minutes

Sections

3

  • Battery
  • 2 steps
  • Keyboard
  • 7 steps
  • Screen
  • 1 step

Flags

1

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

  • BackBlackBerry Pearl 8100

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Before working on the phone, be sure that the device is turned off.
  • Begin by removing the back panel; this can be done by pressing the silver button on the backside of the Blackberry 8100, while simultaneously sliding the back panel off.

Before working on the phone, be sure that the device is turned off.

Begin by removing the back panel; this can be done by pressing the silver button on the backside of the Blackberry 8100, while simultaneously sliding the back panel off.

1024

Step 2

  • Remove the battery located directly below back panel.

Remove the battery located directly below back panel.

Step 3

              Keyboard
  • Using a 1.5 mm Hex screwdriver, remove the two screws that hold the two panels together.

Using a 1.5 mm Hex screwdriver, remove the two screws that hold the two panels together.

Step 4

  • Using the spudger, pry off the small portion of the casing located at the bottom of the phone.

Using the spudger, pry off the small portion of the casing located at the bottom of the phone.

Step 5

  • Using the spudger, pry off the side casings one at a time by wedging it between the inner casing and the sides.

Using the spudger, pry off the side casings one at a time by wedging it between the inner casing and the sides.

Step 6

  • Using a 1.5mm Hex screwdriver, unscrew the two screws, located on the front of the phone, that connect the back and front panels.

Using a 1.5mm Hex screwdriver, unscrew the two screws, located on the front of the phone, that connect the back and front panels.

Step 7

  • Using the spudger, pry off the back body panel by wedging the spudger in between the front and back panels on the side face. Remove the back body panel.

Using the spudger, pry off the back body panel by wedging the spudger in between the front and back panels on the side face. Remove the back body panel.

Step 8

  • Separate the logic board from the front panel.

Separate the logic board from the front panel.

Step 9

  • Gently remove the keyboard from front casing. It should snap out of place.

Gently remove the keyboard from front casing. It should snap out of place.

Step 10

              Screen
  • After removing the logic board, place spudger between the logic board and screen and remove the screen, sliding it slowly away.

After removing the logic board, place spudger between the logic board and screen and remove the screen, sliding it slowly away.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors 


                    Robert Cronin

Member since: 04/08/2010

544 Reputation

                                      6 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Cal Poly, Team 34-57, Forte Spring 2010                        

                                                  Member of Cal Poly, Team 34-57, Forte Spring 2010 



                    CPSU-FORTE-S10S34G57                     


                                            5 Members                     


                                            6 Guides authored