Difficulty

Moderate

Steps

5

Time Required

Suggest a time??

Sections

1

  • Circuit Board and Roller Ball
  • 5 steps

Flags

2

Inconsistent Images

Updating the images on this guide to be more consistent with the prerequisites would increase its awesomeness.

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

  • BackBlackBerry Pearl Flip 8220

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Circuit Board and Roller Ball
  • There are four screws total on the back of the phone casing near edge of battery area.
  • The two closer to the top of the phone are protected by plastic stoppers. Remove them then remove the screws.
  • There are two more screws on either side of where the battery was located. remove them as well.

There are four screws total on the back of the phone casing near edge of battery area.

The two closer to the top of the phone are protected by plastic stoppers. Remove them then remove the screws.

There are two more screws on either side of where the battery was located. remove them as well.

1024

Step 2

  • Remove the bottom plastic piece.
  • This may require prying from a few different directions. The plastic blue prying tool featured here may be required.

Remove the bottom plastic piece.

This may require prying from a few different directions. The plastic blue prying tool featured here may be required.

Step 3

  • Once the keypad is removed, the buttons on the sides of the phone will fall out.
  • You will need to loosen the board from the right side opposite the charging ports.
  • Pull gently towards the right side so the ports clear the plastic casing.
  • Gently flip the board over to the left.

Once the keypad is removed, the buttons on the sides of the phone will fall out.

You will need to loosen the board from the right side opposite the charging ports.

Pull gently towards the right side so the ports clear the plastic casing.

Gently flip the board over to the left.

Step 4

  • On the back of the circuit board you will find a small rectangular blue piece with a black ‘L’ shape in the middle.
  • Gently detach this from the back of the main board.
  • Now you may fully remove the main board.

On the back of the circuit board you will find a small rectangular blue piece with a black ‘L’ shape in the middle.

Gently detach this from the back of the main board.

Now you may fully remove the main board.

Step 5

  • What is left inside the phone is the roller ball.
  • Gently use the plastic blue tool to detach it from the frame.

What is left inside the phone is the roller ball.

Gently use the plastic blue tool to detach it from the frame.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 7 other contributors 


                    Ashley

Member since: 04/15/2013

306 Reputation

                                      3 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       SUNY Cortland, Team 1-5, Getto Spring 2013                        

                                                  Member of SUNY Cortland, Team 1-5, Getto Spring 2013 



                    SUNYCORT-GETTO-S13S1G5                     


                                            3 Members                     


                                            3 Guides authored