Difficulty

Moderate

Steps

5

Time Required

                          15 minutes

Sections

1

  • Logic Board Replacement
  • 5 steps

Flags

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

  • BackBlackberry Torch 9800

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Logic Board Replacement
  • Remove the back cover and the battery.
  • Unscrew the four screws using a T6 screwdriver.
  • Removing the top right screw (with the blue cover) will void the warranty.

Remove the back cover and the battery.

Unscrew the four screws using a T6 screwdriver.

Removing the top right screw (with the blue cover) will void the warranty.

1024

Step 2

  • Remove the side trim using the plastic opening tool.
  • Apply pressure to push the top side of the side trim towards the phone while pulling the bottom away from the phone to remove the side trim.
  • The side trim is fragile and easily fractured, so handful it with care.

Remove the side trim using the plastic opening tool.

Apply pressure to push the top side of the side trim towards the phone while pulling the bottom away from the phone to remove the side trim.

The side trim is fragile and easily fractured, so handful it with care.

Step 3

  • Remove the two screws that have been revealed at the top of the device using the T6 screwdriver.
  • You should now be able to easily lift the back panel from the phone.

Remove the two screws that have been revealed at the top of the device using the T6 screwdriver.

You should now be able to easily lift the back panel from the phone.

Step 4

  • Using your hands, carefully peel the three ribbon cable caps from the logic board.

Using your hands, carefully peel the three ribbon cable caps from the logic board.

Step 5

  • Lift logic board slightly. The logic board will remain attached to the phone by a small antenna wire.
  • Using your hands, carefully lift the clasp attached to the antenna wire straight upward away from the logic board.
  • Make sure not to disconnect the antenna wire from its clasp.
  • The logic board should now be completely separate from the phone.

Lift logic board slightly. The logic board will remain attached to the phone by a small antenna wire.

Using your hands, carefully lift the clasp attached to the antenna wire straight upward away from the logic board.

Make sure not to disconnect the antenna wire from its clasp.

The logic board should now be completely separate from the phone.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 5 other contributors 


                    Keegan Williams

Member since: 02/19/2016

189 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Ohio State, Team 1-5, Garvin Spring 2016                        

                                                  Member of Ohio State, Team 1-5, Garvin Spring 2016 



                    OSU-GARVIN-S16S1G5                     


                                            3 Members                     


                                            3 Guides authored