Difficulty

Moderate

Steps

9

Time Required

                          20 minutes

Sections

1

  • Motherboard
  • 9 steps

Flags

2

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackBlackberry Torch 9810

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Phone cover
  • Remove the back cover of the phone

Remove the back cover of the phone

1024

Step 2

              Battery Removal
  • Remove the battery

Remove the battery

Step 3

              Remove Screws
  • Unscrew the four screws using the T6 screw driver
  • If you remove the screw in red, you void the warranty!

Unscrew the four screws using the T6 screw driver

If you remove the screw in red, you void the warranty!

Step 4

              Wiggle Wiggle
  • Remove front silver trim by using plastic opening tools and wiggle it off.
  • This is difficult to remove, but it should come off if you do it with caution.

Remove front silver trim by using plastic opening tools and wiggle it off.

This is difficult to remove, but it should come off if you do it with caution.

Step 5

              More Screws
  • Once you remove the rim cover, you should find two more screws on the top. Unscrew them using the T6 screw driver.

Once you remove the rim cover, you should find two more screws on the top. Unscrew them using the T6 screw driver.

Step 6

              Remove the Back
  • Use the plastic removal tool to remove the entire back cover.

Use the plastic removal tool to remove the entire back cover.

Step 7

              Small Antenna Wire
  • Unplug the black antenna wire from the logic board.

Unplug the black antenna wire from the logic board.

Step 8

              Remove Ribbon Cables
  • Peel off the three ribbon cables
  • They are orange and located on each side as well as on the top of the logic board
  • The cable circled in yellow is glued to the silver cap. Pull the ribbon cable upward towards the battery area.

Peel off the three ribbon cables

They are orange and located on each side as well as on the top of the logic board

The cable circled in yellow is glued to the silver cap. Pull the ribbon cable upward towards the battery area.

Step 9

              Logic Board
  • Take out your logic board

Take out your logic board

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.

Author

                                      with 4 other contributors 


                    Jocelyn Adorno

Member since: 10/16/2014

296 Reputation

                                      4 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       UMass Dartmouth, Team 6-6, Vijaybhaskar Fall 2014                        

                                                  Member of UMass Dartmouth, Team 6-6, Vijaybhaskar Fall 2014 



                    UMASSD-VIJAYBHASKAR-F14S6G6                     


                                            3 Members                     


                                            4 Guides authored