Difficulty

Moderate

Steps

6

Time Required

                          30 minutes

Sections

1

  • Rear Facing Camera
  • 6 steps

Flags

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

  • BackBlackberry Torch 9810

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Before starting this project you should completely power off your device, disconnect from any external power source, and carefully inspect your device to ensure that is free of any dirt and debris.

Warning if your screen is cracked or damaged it maybe the cause of a nonfunctional front-view and will need to be replaced instead of the actual camera.

What you need

Step 1

              Remove Cover
  • Remove the back cover of the phone

Remove the back cover of the phone

1024

Step 2

              Remove Battery
  • Remove the battery
  • Our phone did not come with a battery. This is where it would be located.

Remove the battery

Our phone did not come with a battery. This is where it would be located.

Step 3

              Unscrew Screws
  • Unscrew the four screws using the T6 screw driver
  • If you remove the screw in red, you void the warranty!

Unscrew the four screws using the T6 screw driver

If you remove the screw in red, you void the warranty!

Step 4

              Wiggle Wiggle
  • Remove front silver trim by using plastic opening tools and wiggle it off.
  • (This is a little difficult to remove) Pull the bottom upward and pull the top downward.

Remove front silver trim by using plastic opening tools and wiggle it off.

(This is a little difficult to remove) Pull the bottom upward and pull the top downward.

Step 5

              Smaller Screws That Must Go
  • Once you remove the rim cover, you should find two more screws on the top. Unscrew them using the T6 screw driver.

Once you remove the rim cover, you should find two more screws on the top. Unscrew them using the T6 screw driver.

Step 6

              Camera Sensor
  • Use the Phillip screw driver to wiggle the camera sensor out.
  • Carefully remove this

Use the Phillip screw driver to wiggle the camera sensor out.

Carefully remove this

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 7 other contributors 


                    Jocelyn Adorno

Member since: 10/16/2014

296 Reputation

                                      4 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       UMass Dartmouth, Team 6-6, Vijaybhaskar Fall 2014                        

                                                  Member of UMass Dartmouth, Team 6-6, Vijaybhaskar Fall 2014 



                    UMASSD-VIJAYBHASKAR-F14S6G6                     


                                            3 Members                     


                                            4 Guides authored