Difficulty

Moderate

Steps

7

Time Required

                          15 - 20 minutes

Sections

3

  • Battery
  • 2 steps
  • Front and Back Casing
  • 4 steps
  • LCD Screen
  • 1 step

Flags

0

  • BackBlackBerry World Edition 8830

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Battery
  • Before beginning this installation, make sure phone is powered off .
  • Turn phone over to the backside.
  • Press down on the lower portion of the back cover.
  • Slide the lower portion down to remove the cover and reveal the battery.

Before beginning this installation, make sure phone is powered off .

Turn phone over to the backside.

Press down on the lower portion of the back cover.

Slide the lower portion down to remove the cover and reveal the battery.

1024

Step 2

  • Remove the battery from the phone.

Remove the battery from the phone.

Step 3

              Front and Back Casing
  • Once the battery is removed, remove the four 9.2 mm screws with the T4 Torx Screwdriver.

Once the battery is removed, remove the four 9.2 mm screws with the T4 Torx Screwdriver.

Step 4

  • Remove side panels with the Plastic Opening Tool by sliding it along the edge of the panel until you can pry it off with the tool.

Remove side panels with the Plastic Opening Tool by sliding it along the edge of the panel until you can pry it off with the tool.

Step 5

  • Remove the back casing using the Plastic Opening Tool
  • Once the back casing is removed the top two buttons are likely to pop out.

Remove the back casing using the Plastic Opening Tool

Once the back casing is removed the top two buttons are likely to pop out.

Step 6

  • Locate the two 9.2mm screws on the upper inside casing
  • Remove them using the T4 Torx Screwdriver
  • Slide off the front casing once the screws are removed.
  • Trackball will fall out once the casing is removed.

Locate the two 9.2mm screws on the upper inside casing

Remove them using the T4 Torx Screwdriver

Slide off the front casing once the screws are removed.

Trackball will fall out once the casing is removed.

Step 7

              LCD Screen
  • Disconnect the tab attached to the interior casing from the LCD Screen by gently pulling the tab up and away from the phone.
  • Use the Plastic Opening Tool to pry the LCD Screen out.

Disconnect the tab attached to the interior casing from the LCD Screen by gently pulling the tab up and away from the phone.

Use the Plastic Opening Tool to pry the LCD Screen out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Martha de Maria y Campos

Member since: 04/12/2012

55 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Cal Poly, Team 17-27, Amido Spring 2012                        

                                                  Member of Cal Poly, Team 17-27, Amido Spring 2012 



                    CPSU-AMIDO-S12S17G27                     


                                            4 Members                     


                                            8 Guides authored