Blossom Ultrasonic Essential Oil Diffuser Arm 510Gy Fan Replacement Repair Guide

Difficulty

Easy

Steps

9

Time Required

                          30 minutes            

Sections

1

• Fan
• 9 steps

Flags

0

• BackHousehold Item

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Before disassembling the diffuser, make sure there is no oil or water left in the diffuser and make sure the diffuser is unplugged.

What you need

Step 1

              Fan               

• Make sure the diffuser is not plugged into a socket and that there is no water or oil near or in the diffuser before beginning the guide.
• Use a Phillips #2 screwdriver to remove the four 8 mm screws on the bottom of the diffuser.

Make sure the diffuser is not plugged into a socket and that there is no water or oil near or in the diffuser before beginning the guide.

Use a Phillips #2 screwdriver to remove the four 8 mm screws on the bottom of the diffuser.

1024

Step 2

• Lift the ceramic top of the oil diffuser.
• Then lift off the plastic top off the diffuser.

Lift the ceramic top of the oil diffuser.

Then lift off the plastic top off the diffuser.

Step 3

• Lift the last plastic lid.
• You will see a circuit board, and there will be a cord connecting it to the circuit board.

Lift the last plastic lid.

You will see a circuit board, and there will be a cord connecting it to the circuit board.

Step 4

• Gently unplug the cord from the circuit board.
• Place the plastic lid somewhere safe on the a flat surface.

Gently unplug the cord from the circuit board.

Place the plastic lid somewhere safe on the a flat surface.

Step 5

• Remove the plastic ring and place somewhere safe on a flat surface.

Remove the plastic ring and place somewhere safe on a flat surface.

Step 6

• Remove two Truss head 4 mm screws with a Phillips #2 screwdriver and place safely nearby.

Remove two Truss head 4 mm screws with a Phillips #2 screwdriver and place safely nearby.

Step 7

• Gently lift the circuit board onto it’s side
• The white connector plugs the fan into the circuit board.

Gently lift the circuit board onto it’s side

The white connector plugs the fan into the circuit board.

Step 8

• Unplug the white connector.
• There are four #M1 6 mm Phillips pan head screws holding down the fan.

Unplug the white connector.

There are four #M1 6 mm Phillips pan head screws holding down the fan.

Step 9

• Remove the #M1 6 mm screws with a Phillips #2 screwdriver while holding down the fan.
• Gently lift the fan and place the fan someplace safe on the flat surface.

Remove the #M1 6 mm screws with a Phillips #2 screwdriver while holding down the fan.

Gently lift the fan and place the fan someplace safe on the flat surface.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Muniira Mohamoud                     

Member since: 01/18/2022

169 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       York University, Team R-17, Melo-Thaiss Winter 2022                        

                                                  Member of York University, Team R-17, Melo-Thaiss Winter 2022 



                    YORK-MELO-THAISS-W22SRG17                     


                                            1 Member                     


                                            1 Guide authored