Difficulty

Moderate

Steps

6

Time Required

                          7 - 15 minutes

Sections

3

  • Battery
  • 2 steps
  • Volume and Lock Button
  • 2 steps
  • Ear Speaker
  • 2 steps

Flags

0

  • BackBLU Dash 3.5

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Start by locating the slot on the lower right corner of the device.
  • Insert the opening tool into the slot.
  • Pry the back cover off. Once the corner is off, continue around the perimeter of the phone pulling the back off with your fingers.
  • A fingernail can work to open the back in place of an opening tool.

Start by locating the slot on the lower right corner of the device.

Insert the opening tool into the slot.

Pry the back cover off. Once the corner is off, continue around the perimeter of the phone pulling the back off with your fingers.

A fingernail can work to open the back in place of an opening tool.

1024

Step 2

  • Locate the indentation at the bottom of the battery.
  • Insert your thumb and pull the battery out.

Locate the indentation at the bottom of the battery.

Insert your thumb and pull the battery out.

Step 3

              Volume and Lock Button
  • Use the 000 Phillips screwdriver to remove the four 4.5 mm screws from the corners of the interior back panel.
  • Use the opening tool to pry open the plastic back panel to expose the motherboard.

Use the 000 Phillips screwdriver to remove the four 4.5 mm screws from the corners of the interior back panel.

Use the opening tool to pry open the plastic back panel to expose the motherboard.

Step 4

  • Remove volume and lock buttons by lifting them gently from the casing.

Remove volume and lock buttons by lifting them gently from the casing.

Step 5

              Ear Speaker
  • Use tweezers to lift the screen wire tab where the cable is connected.
  • Use the opening tool to pry the motherboard from the front face plate.

Use tweezers to lift the screen wire tab where the cable is connected.

Use the opening tool to pry the motherboard from the front face plate.

Step 6

  • Use opening tool to pry speaker from front panel.
  • Note prong direction

Use opening tool to pry speaker from front panel.

Note prong direction

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Aaron Boehm

Member since: 03/01/2017

201 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       IUPUI, Team S1-G2, Harley Spring 2017                        

                                                  Member of IUPUI, Team S1-G2, Harley Spring 2017 



                    IUPUI-HARLEY-S17S1G2                     


                                            4 Members                     


                                            3 Guides authored