Difficulty

Moderate

Steps

6

Time Required

                          35 minutes

Sections

3

  • Battery
  • 2 steps
  • Volume and Lock Button
  • 2 steps
  • Screen Assembly
  • 2 steps

Flags

0

  • BackBLU Dash 3.5

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Start by locating the slot on the lower right corner of the device.
  • Insert the opening tool into the slot.
  • Pry the back cover off. Once the corner is off, continue around the perimeter of the phone pulling the back off with your fingers.
  • A fingernail can work to open the back in place of an opening tool.

Start by locating the slot on the lower right corner of the device.

Insert the opening tool into the slot.

Pry the back cover off. Once the corner is off, continue around the perimeter of the phone pulling the back off with your fingers.

A fingernail can work to open the back in place of an opening tool.

1024

Step 2

  • Locate the indentation at the bottom of the battery.
  • Insert your thumb and pull the battery out.

Locate the indentation at the bottom of the battery.

Insert your thumb and pull the battery out.

Step 3

              Volume and Lock Button
  • Use the 000 Phillips screwdriver to remove the four 4.5 mm screws from the corners of the interior back panel.
  • Use the opening tool to pry open the plastic back panel to expose the motherboard.

Use the 000 Phillips screwdriver to remove the four 4.5 mm screws from the corners of the interior back panel.

Use the opening tool to pry open the plastic back panel to expose the motherboard.

Step 4

  • Remove volume and lock buttons by lifting them gently from the casing.

Remove volume and lock buttons by lifting them gently from the casing.

Step 5

              Screen Assembly
  • Use tweezers to lift the tab where the cable is connected.
  • Use the opening tool to pry the motherboard from the front face plate.

Use tweezers to lift the tab where the cable is connected.

Use the opening tool to pry the motherboard from the front face plate.

Step 6

  • Use opening tool to pry off the screen.
  • Use a soldering tool to melt the contact between the motherboard and the screen
  • Solder new screen contacts to the motherboard.

Use opening tool to pry off the screen.

Use a soldering tool to melt the contact between the motherboard and the screen

Solder new screen contacts to the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 7 other contributors 


                    Jeffrey Dlugosz

Member since: 09/29/2015

104 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Ohio State, Team 1-2, Garvin Fall 2015                        

                                                  Member of Ohio State, Team 1-2, Garvin Fall 2015 



                    OSU-GARVIN-F15S1G2                     


                                            4 Members                     


                                            2 Guides authored