Difficulty

Moderate

Steps

5

Time Required

                          20 - 30 minutes

Sections

2

  • Battery
  • 2 steps
  • Display Cable
  • 3 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackBlu Dash 5.0 Dual SIM

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Find the small slot on the bottom left corner of the back panel.
  • Slide the spudger into the small slot and lightly twist it. This will cause the corner of the back panel to pop up.
  • When the back panel is loose enough, use your fingers to remove it completely.

Find the small slot on the bottom left corner of the back panel.

Slide the spudger into the small slot and lightly twist it. This will cause the corner of the back panel to pop up.

When the back panel is loose enough, use your fingers to remove it completely.

1024

Step 2

  • With the back panel off, you should see a large white rectangle. This is the battery. Slide the spudger under the indent on the bottom right of the battery and pull it up.

With the back panel off, you should see a large white rectangle. This is the battery. Slide the spudger under the indent on the bottom right of the battery and pull it up.

Step 3

              Display Cable
  • Using the PH00 Phillips head screwdriver unscrew the screws holding the panel down, making sure to keep track of the position of the screws.
  • The screw holes with the red circle around them hold screws with a 3.5 mm length.
  • The screw holes with the orange circle around them hold screws with a 2.5 mm length.

Using the PH00 Phillips head screwdriver unscrew the screws holding the panel down, making sure to keep track of the position of the screws.

The screw holes with the red circle around them hold screws with a 3.5 mm length.

The screw holes with the orange circle around them hold screws with a 2.5 mm length.

Step 4

  • Insert the plastic opening tool into a corner of the plastic panel and gently pry it away from the rest of the phone.
  • Do this for each corner until the panel pops up.

Insert the plastic opening tool into a corner of the plastic panel and gently pry it away from the rest of the phone.

Do this for each corner until the panel pops up.

Step 5

  • Along the right side of the phone you will see a long black wire with 2 gold end pieces on the end. This is the display cable.
  • To disconnect the gold end pieces from the motherboard, take the tweezers and gently but firmly pull upwards. Do this for both ends and the wire will disconnect.

Along the right side of the phone you will see a long black wire with 2 gold end pieces on the end. This is the display cable.

To disconnect the gold end pieces from the motherboard, take the tweezers and gently but firmly pull upwards. Do this for both ends and the wire will disconnect.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      8 other people completed this guide.

Author

                                      with 5 other contributors 


                    Dashaya Toney

Member since: 10/27/2014

876 Reputation

                                      3 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       UMass Dartmouth, Team 4-7, Miles Fall 2014                        

                                                  Member of UMass Dartmouth, Team 4-7, Miles Fall 2014 



                    UMASSD-MILES-F14S4G7                     


                                            3 Members                     


                                            3 Guides authored